Register your product and get support at EN User manual AJ3570
A n m l k j a i b h g f e c d
B C
D
E a b HR +/- SET TIME HR c d MIN MIN+/M IN CLOCK
F a b SET AL 1 HR +/- SET AL 2 c HR d MIN +/M IN CLOCK
G a c b RADIO FM/MW TUNING +/HR HR H VOL
EN 1 Important Safety • • • • • • • • • • • • Read these instructions. Heed all warnings. Follow all instructions. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
2 Your clock radio Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. What’s in the box B Overview of the main unit A 3 Get started Always follow the instructions in this chapter in sequence. Install battery D Warning •• Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire. •• Danger of explosion if battery is incorrectly replaced.
Note •• You can only use AC power as power supply. The lithium CR2032 battery is only for back-up purpose. •• When power is disconnected, the display backlight is off. When appears on the display panel ( ) , replace the battery as indicated. Connect power C Caution •• Risk of product damage! Ensure that the power voltage corresponds to the voltage printed on the back or underside of the clock radio. •• Risk of electric shock! When you unplug the AC adapter, always pull the plug from the socket.
For Europe: Western European Time (WET) +0 Central European Time (CET) +1 (Default) Eastern European Time (EET) +2 Moscow Standard Time (MST) +3 Set clock E In standby mode, you can set clock manually. Select DST (daylight saving time) mode For countries with daylight saving time (DST), the clock radio offers you DST option to adjust summer time. In standby mode, press and hold 12/24H·DST ( ) for two seconds. »» The clock advances by one hour. Tip •• To exit DST mode, repeat the above operation.
Select alarm sound To select the last heard channel or buzzer as alarm sound, switch AL1/ AL2 RADIO·BUZZ ( ) to left or right. Activate/deactivate alarm timer 1 2 Press AL1/AL2 ( ) to view alarm settings. Press AL1/AL2 again to activate or deactivate the alarm timer. or appears if alarm timer is on and disappears if it is »» off. • To stop alarm, press the corresponding AL1/AL2. • The alarm repeats ringing for the next day. Note •• When alarm sounds, you cannot adjust volume by rotating VOL ( ).
5 Listen to radio Tune to radio stations G Tip •• Position the antenna as far as possible from TV, VCR, or other radiation source. •• For better reception, fully extend and adjust the position of the antenna. Store radio stations automatically You can store up to 20 FM radio stations and 10 MW radio stations. 1 Press RADIO ( ) to turn on the radio. 2 Press and hold PROG ( ) for two seconds.
Note •• To remove a pre-stored station, store another station in its place. Select a preset radio station In tuner mode, press PRESET +/- ( ) to select a preset number. Adjust volume H 6 Other features Set sleep timer This clock radio can switch to standby mode automatically after a preset period. Press SLEEP ( ) repeatedly to select sleep timer period (in minutes). »» When the sleep timer is activated, is displayed. To deactivate the sleep timer, press SLEEP repeatedly until [OFF] (off) appears.
Adjust display brightness Press BRIGHTNESS ( ) repeatedly to select different brightness levels: L3 (High), L2 (mid), L1 (low), and [Auto] (auto). L3 L2 7 L1 Auto Product information Note •• Product information is subject to change without prior notice. Specifications Amplifier Rated Output Power 0.
Tuner Tuning Range FM: 87.5 - 108 MHz MW: 522-1620 KHz Sensitivity - Mono, 26dB S/N Ratio FM: <22 dBu MW: <92 dBuV/M Search Selectivity FM: <28 dBu MW:<98 dBuV/M Total Harmonic Distortion FM: <3% MW:<5% Signal to Noise Ratio FM: >45 dB MW:>40 dB General information AC power 220-240 V ~, 50/60Hz Operation Power Consumption < 3W Standby Power Consumption < 2W Dimensions - Main Unit (W x H x D) 179.5 x 85.5 x 76 mm Weight - With Packing - Main Unit 0.7 kg 0.
8 Troubleshooting Warning •• Never remove the casing of this apparatus. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www.philips.com/welcome). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available.
Note •• The type plate is located on the bottom of the apparatus. Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. When this crossed-out wheeled bin symbol is attached to a product it means that the product is covered by the European Directive 2002/96/ EC. Please inform yourself about the local separate collection system for electrical and electronic products.
of batteries because correct disposal helps to prevent negative consequences for the environmental and human health. Environmental information All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet.) Your system consists of materials which can be recycled and reused if disassembled by a specialized company.
© 2011 Koninklijke Philips Electronics N.V. All rights reserved. AJ3570_12_UM_V1.