Always there to help you Register your product and get support at www.philips.
1 Important Safety Notice English Contents 2 2 3 2 Your Docking Entertainment System 4 Introduction What’s in the box Overview of the main unit 3 Get started Install batteries Connect power Turn on Set time and date 4 Play Play from iPod/iPhone/iPad Play from an external device 5 Listen to radio Tune to a radio station Program radio stations 6 Other features Set the alarm timer Set the sleep timer Adjust display brightness 7 Adjust sound Adjust volume level Select a sound effect 4 4 5 7 7 7 8 8 9 9
1 Important Caution Danger of explosion if battery is incorrectly replaced. Remove battery if it is exhausted or will not be used for a long time. Batteries contain chemical substances, so they should Safety Know these safety symbols be disposed of properly. Perchlorate Material-special handling may apply. See www.dtsc.ca.gov/hazardouswaste/perchlorate. This ‘bolt of lightning’ indicates uninsulated material within your unit may cause an electrical shock.
Do not place any sources of danger on WKH V\VWHP H J OLTXLG ÀOOHG REMHFWV OLJKWHG candles). Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. Notice $Q\ FKDQJHV RU PRGLÀFDWLRQV PDGH WR WKLV device that are not expressly approved by WOOX Innovations may void the user’s DXWKRULW\ WR RSHUDWH WKH HTXLSPHQW This product complies with the radio LQWHUIHUHQFH UHTXLUHPHQWV RI WKH (XURSHDQ Community.
2 Your Docking Entertainment System Congratulations on your purchase, and ZHOFRPH WR 3KLOLSV 7R IXOO\ EHQHÀW IURP WKH support that Philips offers, register your product at www.philips.com/welcome. Introduction With this unit, you can enjoy music from iPod/ iPhone/iPad and listen to radio or other audio devices. Your iPod/ iPhone/iPad and radios can be set as alarm sources. You can set two alarms to go off at different time.
English Overview of the main unit q p AC ~ AU D I O I N FM ANTENNA o n m a VOL b c SET TIME TUNE PRE SET PROG SCAN PRE SET d l k j TUNE VOL i e AL 1 SNOOZE AL 2 BRIGHTNESS f f h g a VOL +/VOL Increase/decrease volume. b DOCK 1 In Dock 1 mode, start or pause play. In other modes, select Dock 1 source. c SET TIME In standby mode, set day, month and year. In other modes, enable/disable DBB (Dynamic Bass Boost) or select a DSC (Digital Sound Control) sound effect.
e /SOURCE Press and hold to turn on the unit or switch to standby mode. Stop alarm. Select a source: DOCK 1/DOCK 2, FM or AUDIO IN. f AL1/AL2 Set alarm. View alarm settings. Activate/deactivate alarm timer. g Display panel Show the current status. h SNOOZE/BRIGHTNESS Snooze alarm. Adjust the display brightness. i SLEEP Set the sleep timer. j PRESET +/PRESET Skip to next/previous track. Select a preset radio program.
Caution Risk of explosion! Keep batteries away from heat, English 3 Get started VXQVKLQH RU ÀUH 1HYHU GLVFDUG EDWWHULHV LQ ÀUH Caution Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in VHTXHQFH If you contact Philips, you will be asked for the model and serial number of this apparatus.
Turn on Press and hold . » The unit switches to the last selected source. Switch to standby Press and hold again to switch the unit to standby mode. » The time and date (if set) appear on the display panel. Select source Press SOURCE repeatedly to select from DOCK 1/Dock 2, FM and AUDIO IN. Set time and date 1 In standby mode, press and hold SET TIME for 2 seconds. » [24H ] begins to blink, and you can hear a beep. 2 Press TUNE+ or TUNE- to select the 12/24 hour format.
Play from iPod/iPhone/iPad Listen to the iPod/iPhone/iPad 1 Press SOURCE repeatedly to select DOCK 1 or DOCK 2 mode. 2 Place the iPhone/iPod/iPad into the Dock 1 or Dock 2. English 4 Play You can enjoy audio from iPod/iPhone/iPad through this unit.
Play from an external device You can also listen to an external audio device through this unit. 1 Press SOURCE repeatedly to select the AUDIO IN source. 2 Connect a 3.5mm audio link cable (not supplied) to: the AUDIO IN jack (3.5mm) on the back of the unit. the headphone jack on an external device. » the screen displays scrolling text message [AUDIO IN]; and shows date and time. 3 Start to play the device (see the device user manual).
Note Only FM radio reception is available on this unit. Tune to a radio station Program radio stations manually 1. Press SOURCE repeatedly to enter the FM mode. 2. Press TUNE+/TUNE- to tune to a radio station. 3. Press PROG/SCAN. » $ SRVLWLRQ QXPEHU ÁDVKHV 4. Press OK to save current radio station to the selected position. Tip Use an FM antenna for optimal reception. Fully extend and adjust the position of the antenna.
6 Other features Set the alarm timer You can set two alarms at different times. Activate and deactivate the alarm timer When an alarm setting is shown on the screen, press AL1/AL2 repeatedly to activate or deactivate the timer. » If the timer is activated, [ AL 1] or [ AL2] is displayed. » If the timer is deactivated, [ AL1] or [ AL2] disappears. Note Ensure that you have set the clock correctly. 1 Press and hold AL1 or AL2. » The hour digits begin to blink, and you can hear one beep.
English Set the sleep timer This unit can switch to standby automatically after a set period of time. Press SLEEP repeatedly to select from 120, 90, 60, 45, 30 and 15 minutes. » When the sleep timer is activated, the display shows . To deactivate sleep timer 1 Press SLEEP repeatedly until [OFF] (off) is displayed. » The sleep timer is deactivated, disappears on the display. Adjust display brightness :KHQ QR DODUP LV ÀULQJ SUHVV BRIGHTNESS repeatedly to select different levels of display brightness.
7 Adjust sound Adjust volume level During play, press VOL +/- to increase/decrease the volume level step by step. Tip Press and hold VOL +/- to increase/decrease the volume at faster speed. Select a sound effect During play, press SET TIME repeatedly to select from a preset sound effect and turn on/ off dynamic bass enhancement.
8 Product information Note Product information is subject to change without prior notice. 6SHFLÀFDWLRQV AC power Operation Power Consumption Standby Power Consumption (clock display) Dimensions - Main Unit (W x H x D) Weight (Main unit, without packing) 110-240V~,50/60Hz 44 W <1 W 260 x 138 x 185 mm 1.13 kg $PSOLÀHU Total output power )UHTXHQF\ 5HVSRQVH Signal to Noise Ratio Aux Input (Audio in) 8W 80 Hz -16 kHz, ±3dB G%$ 0.
9 Troubleshooting Caution Never remove the casing of this apparatus. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, check the following points before UHTXHVWLQJ VHUYLFH ,I WKH SUREOHP UHPDLQV unsolved, go to the philips web site (www. philips.com/support). When you contact philips, ensure that your apparatus is nearby and the model number and serial number are available.
Specifications are subject to change without notice 2014 © WOOX Innovations Limited. All rights reserved.Philips and the Philips’ Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used by WOOX Innovations Limited under license from Koninklijke Philips N.V. AJ7260D_12_UM_V3.