User Manual

ManualsBrandsPhilips ManualsEar thermometerPHILIPS AVENT Smart Ear Thermometer

ENGLISH

Introduction

Congratulations on your purchase and welcome

to Philips! To fully benet from the support that

Philips oers, register your product at

www.philips.com/welcome.

Intended use

The product is intended for measuring the

temperature of the human body via the ear canal

by an infrared sensor. The device is intended for all

ages in a home environment.

General

This Philips Avent uGrow smart ear thermometer

has been developed for accurate and fast human

body temperature measurements in the ear in the

adjusted mode.

Research indicates that the ear is an ideal site

for taking the body temperature. The body core

temperature is regulated by the hypothalamus (Fig.

2). The hypothalamus (1) shares the same blood

supply as the tympanic membrane (2).

Measurement results can be transmitted via

Bluetooth® to the Philips Avent uGrow app for

charting and tracking purposes.

General description (Fig. 1)

1 Protection cap

2 Infrared sensor

3 Probe tip

4 History icon

5 Bluetooth® icon

6 Battery symbol

7 Temperature display

8 Power button

9 Temperature light ring

10 °C/°F selection button

11 Battery compartment

12 Battery cover

Important safety information

Read this important information carefully before

you use the device and save it for future reference.

Warning

- Do not measure the body temperature at the

ear site if the ear is inamed or infected.

- Keep the device out of the reach of children

and pets to avoid inhalation or swallowing of

small parts. Children may not be able to use the

device according to the instructions in this user

manual. It is not a toy.

- Do not throw disposable batteries into re.

Batteries may explode.

- Do not put the device in a wet ear canal after

swimming or bathing. This may cause injury to

the ear canal.

SCH740

www.philips.com/avent

Philips Consumer Lifestyle BV

Tussendiepen 4, 9206 AD Drachten, Netherlands

Trademarks owned by the Philips Group.

Find the latest user manual on

www.philips.com/support

4213.354.3816.6

www.philips.com

>75% recycled paper

>75% papier recyclé

1 43

1098

75 6

1311 12

161514

222120

1917 18

Summary of content (5 pages)

PAGE 1
2 1 3 4 1 Introduction 2 SCH740 2 5 6 7 3 The product is intended for measuring the temperature of the human body via the ear canal by an infrared sensor. The device is intended for all ages in a home environment. 5 6 8 9 10 General 10 11 12 13 This Philips Avent uGrow smart ear thermometer has been developed for accurate and fast human body temperature measurements in the ear in the adjusted mode. Research indicates that the ear is an ideal site for taking the body temperature.
PAGE 2
- Do not use the device if it is broken or damaged. Using a broken or damaged device may cause injury. Caution - - - - - - - - Only use the device as described in this user manual. Do not use it for any other purpose. The device is not intended as a substitute for consulting a doctor. Measurement results are for reference only. When the device is used to measure the temperature of a child, it has to be operated by an adult. Adults can measure their own temperature.
PAGE 3
5 Press the power button to start the measurement. (Fig. 12) - When the measurement is done, you hear 2 beeps. 6 Remove the probe tip from the ear canal (Fig. 13). - The display shows the measured temperature. The temperature light ring around the power button may light up red, depending on the measurement result. Note: The temperature display on the device shows the measurement result for 30 seconds or until you perform a new measurement.
PAGE 4
Problem Possible cause and solution Symbol for WEEE, waste electrical and electronical equipment. Electrical waste products should not be disposed of with household waste. Please recycle where facilities exist. Check with your local authority or retailer for recycling advice and see chapter 'Battery recycling'. Ensure that the thermometer is pointed correctly towards the eardrum (Fig. 10). An incorrect measurement position (Fig. 11) might lead to incorrect measurement results.
PAGE 5
Recommended separation distance: Separation distance according to frequency of transmitter (m) d = 1.2 √P d = 1.2 √P 80 MHz to 800MHz d = 2.3 √P 800 MHz to 2.5 GHz where P is the maximum output power rating of the transmitter in watts (W) according to the transmitter manufacturer and d is the recommended separation distance in metres (m). Field strengths from fixed RF transmitters, as determined by an electromagnetic site survey (a), should be less than the compliance level in each frequency range (b).