MP3-CD Soundmachine User Manual Manuel d'utilisation Manual del usario AZ1032 AZ1033 Meet Philips at the Internet http://www.philips.
1 1 2 3 4 8 9 CD/MP3 OFF TAPE TUNER BASS BOOST OFF ON VOLUME NEXT PREVIOUS PAUSE PROG MODE 10 32 REW IO CASSETT F.FWD CD RAD iR STOP • EJECT Z A 0 ! EC E R O RD ALBUM - E ALBUM + PLAY R REC STOP PLAY/ PAUSE LIFT T O OPEN 53 60 88 92 96 FM MHz 108 107 106 104 100 160 140 120 100 80 70 kHz x10 MW BAND MW FM FM ST.
! X C B A A 6 5 4 3 0 9 8 7
Important notes for users in the U.K. Remove fuse cover and fuse. Fix new fuse which should be a BS1362 5 Amp, A.S.T.A. or BSI approved type. Refit the fuse cover. Mains plug This apparatus is fitted with an approved 13 Amp plug.To change a fuse in this type of plug proceed as follows: 1. 2. 3. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 5 Amp.
English Supplied Accessories – AC power cord – Remote control Top and front panels (See 1) 1 Source selector: CD/MP3,TAPE/OFF, TUNER – selects CD/MP3, tape or radio source of sound – power off switch 2 BASS BOOST – turns the bass enhancement on/off. 3 VOLUME – adjusts volume level. 4 Cassette recorder keys: PAUSE ; – pauses playback or recording STOP•EJECT 9/ – stops playback or recording. – opens the cassette holder. F.
General operation General Operation/Tuner 1 2 Switching on and off and selecting functions To switch on, push the Source selector slider to CD, TUNER, or TAPE/OFF as desired. To switch off, push the Source selector slider to TAPE/OFF and check the cassette keys are released. Helpful hints: – To change from TAPE to TUNER or CD function, or when you are switching off the set: first, make sure you press the tape STOP•EJECT 9/ key to end playback and all the cassette keys are released.
CD/MP3 Player Programming track numbers You may store up to 20 tracks (for MP3: 10 tracks) in the desired sequence. If you like, store any track more than once. 1 In the stop position, press PROG to activate programming. ➜ Display: PROG and P01 flash, indicating the start of the program. (See 9) For Audio CD: 2 Repeat steps 2 to 3 to select and store all desired tracks in this way. ➜ Display shows ---after 20 tracks are stored To play your programme, press 2/;.
Maintenance & safety (see !) • • • Always close the CD-tape door to avoid dust on the lens. Sudden changes in the surrounding temperature can cause condensation on the lens of your CD player. Playing a CD is then not possible. Do not attempt to clean the lens but leave the set in a warm environment until the moisture evaporates. The lens of the CD player should never be touched! If the CD player cannot read CDs correctly, use a cleaning CD to clean the lens before taking the set to repair.