Register your product and get support at AZ202C EN User manual
English 1 Important Safety Important Safety Instructions a Read these instructions. b Keep these instructions. c Heed all warnings. d Follow all instructions. e Do not use this apparatus near water. f Clean only with dry cloth. g Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. h Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
j Only use attachments/accessories specified by the manufacturer. k Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. l Unplug this apparatus during lightning storms or when unused for long periods of time. m Refer all servicing to qualified service personnel.
o Apparatus shall not be exposed to dripping or splashing. Do not place any sources of danger on the apparatus (e.g. liquid filled objects, lighted candles). Important notes for users in the U.K. How to connect a plug The wires in the mains lead are coloured with the following code: blue = neutral (N), brown = live (L). As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows: • Connect the blue wire to the terminal marked N or coloured black.
The severed plug must be disposed off to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere. Warning •• •• •• •• Never remove the casing of this apparatus. Never lubricate any part of this apparatus. Never place this apparatus on other electrical equipment. Keep this apparatus away from direct sunlight, naked flames or heat. •• Never look into the laser beam inside this apparatus.
Notice This product complies with the radio interference requirements of the European Community. Any changes or modifications made to this device that are not expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment. Recycling Your product is designed and manufactured with high quality materials and components, which can be recycled and reused.
potentially negative consequences on the environment and human health. Recording and playback of material might require consent. See Copyright Act 1956 and The Performer’s Protection Acts 1958 to 1972. Environmental information All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), paper pulp (buffer) and polyethylene (bags, protective foam sheet.
2 Your CD Soundmachine Introduction With this CD Soundmachine, you can: • play audio discs • listen to FM/MW radio • enjoy music from external devices • program the play sequence of tracks Dynamic Bass Boost (DBB) helps you to maximize music enjoyment.
Overview of the main unit a b CD CD SOUNDMACHINE AZ202 FM MW OFF MP3LINK c d e f g h DBB DBB ON OFF m l k j i a LIFT-OPEN • Open/close the disc compartment. b Source selector • Select a source: CD, FM, or MW. • Turn off the unit. c MP3 LINK • Jack for an external audio device. d • Play track/tracks randomly.
• e Play track/tracks repeatedly. VOLUME • Adjust volume. / f • • Skip to the previous/next track. Search within a track. • Stop play. • Start or pause play. g h i Display panel • Display current status. j PROGRAM • Program tracks and browse the program. k Tuning button • Tune to a FM/MW radio station. l DBB ON/OFF • Turn on/off dynamic bass boost.
3 Get started Caution •• Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of your apparatus. The model number and serial number are on the bottom of your apparatus. Write the numbers here: Model No. __________________________ Serial No.
Connect power Warning •• Risk of product damage! Ensure that the power supply voltage corresponds to the voltage printed on the back or the underside of the apparatus. •• Risk of electric shock! When you disconnect the AC power, always pull the plug from the socket. Never pull the cord. Note •• Install the apparatus near the power supply socket and where the power plug can be easily reached. 1 Connect the power cord to: • the AC MAINS jack on the unit • the power supply socket.
Tip •• To switch the apparatus off completely, disconnect the power cord from the power supply socket. Note •• To save energy: after use, turn off the apparatus. Turn on 1 Push the source selector to CD, FM or MW. Turn off 1 Push the source selector to OFF.
4 Play Play disc 1 2 3 Push the source selector to CD. 4 Press to start play. • To pause/resume play, press . • To stop play, press . • To select another track, press / . • To search within a track, press and hold release to resume normal play. Lift to open the disc compartment. Insert a disc with the printed side facing up, then close the disc compartment. / , then Listen to the radio Tune to a radio station 1 2 Push the source selector to FM or MW. Turn TUNING to tune to a station.
Listen to an external device You can listen to an MP3 player through this apparatus. Note •• When you connect an external device to MP3 LINK jack, the apparatus switches to MP3 LINK source automatically. 1 Use a 3.5mm plugs cable (not supplied) on both ends to connect MP3 LINK jack (3.5mm) on this apparatus and the headphone jack on an MP3 player. 5 Play options Adjust volume 1 During play, turn VOLUME to increase/decrease the volume level.
• [REP ALL](repeat all) - repeat an entire CD/program. Shuffle 1 Press to play all tracks randomly. • [SHUFFLE] (shuffle) - play tracks randomly. Program tracks You can program a maximum of 20 tracks. 1 In CD mode, at the stop position, press PROGRAM to activate the program mode. 2 Press / to select a track number, then press PROGRAM to confirm. 3 Repeat steps 2 to 3 to program more tracks. 4 Press to play the programmed tracks. »» During play, [PROG] (program) is displayed. • • .
6 Product information Note •• Product information is subject to change without prior notice. Specifications Disc Laser Type Semiconductor Disc Diameter 12cm/8cm Support Disc CD-DA, CD-R, CD-RW Audio DAC 24Bits / 44.1kHz Total Harmonic Distortion <1% Frequency Response 60Hz -16kHz S/N Ratio >62dBA Tuner Tuning Range FM: 87.
General Power supply AC: 220 - 240V, 50/60 Hz DC: 9V, 1.5 x 6 R14/UM2 Operation Power Consumption 15 W Standby Power Consumption <1W Dimensions - Main Unit (W x H x D) 297 x 112 x 264 mm Weight 1.6 kg Maintenance Clean the cabinet • Use a soft cloth slightly moistened with a mild detergent solution. Do not use a solution containing alcohol, spirits, ammonia or abrasives. Clean discs • When a disc becomes dirty, clean it with a cleaning cloth. Wipe the disc from the centre out.
7 Troubleshooting Warning •• Never remove the casing of this apparatus. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www.philips.com/welcome). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available.
No disc detected •• Insert a disc. •• Check if the disc is inserted upside down. •• Wait until the moisture condensation at the lens has cleared. •• Replace or clean the disc. •• Use a finalized CD or correct format disc. Poor radio reception •• Increase the distance between the unit and your TV or VCR. •• Fully extend the FM antenna.
© 2010 Koninklijke Philips Electronics N.V. All rights reserved. AZ202C_05_UM_V1.