AZ 2755 Portable CD Mini System POWER AZ2755CD AZ2755 CDRADIO RADIO CASSETTEERECORDE CASSETT RECORDERR DBB SHUFFLE CD TUNER TAPE REPEAT PROG TUNING STOP SEARCH PLAY/PAUSE FM MHz 88 MW KHz 530 • 92 600 • 96 700 • 900 100 • 104 1160 1340 • 108 1600 MHz KHz FM FM BAND MW MW BASS REF LEX SPE AKER SYS TEM ELECTRO NIC SOU RCE SELE CT DECK A RECORD PLAYBACK ACCO USTIC BA SS LEN S RECORD REC ORD PLAYY PLA SEARCH SEA RCH DECK B PLAYBACK STOP/EJEC STOP /EJECTT PAUSE PAU SE PL
AZ 2755 /14 page 3 % $ 1 23 54 6 7 POWER AZ2755 CD RADIO CASSETTE RECORD ER DBB SHUFFLE CD TUNER TAPE PROG TUNING REPEAT STOP SEARCH PLAY/PAUSE FM MHz 88 MW KHz 530 • 92 600 • 96 700 • 900 100 • 104 1160 1340 • 108 1600 MHz KHz FM BAND FM MW MW BASS REF LEX SPE AKER SYS TEM ELECTRONIC SOURCE SELECT DECK A RECORD PLAYB ACK ACCO USTIC BA SS LEN S RECORD REC ORD PLAYY PLA SEARCH SEA RCH DECK B PLAYBACK STOP/EJE STO P/EJECT CT PAU PAUSE SE PLAY PLAY SEARCH SEAR
AZ 2755 /14 page 4 CONTROLS English TOP AND FRONT PANELS 1 POWER - to switch the set ON/OFF 2 DBB (Dynamic Bass Boost) - to enhance bass response 3 VOLUME 4 , 3 - to adjust volume level 4 CD, TUNER, TAPE - to select source of sound 5 REMOTE SENSOR - for the remote control 6 CD Display - to show the CD functions 7 OPEN - to open/ close the CD door 8 p 3.
AZ 2755 /14 page 5 POWER SUPPLY English Whenever convenient, use the power supply if you want to conserve battery life. Make sure you remove the plug from the set and wall socket before inserting batteries. BATTERIES (OPTIONAL) 1. Open the battery compartment and insert six batteries, type R-20, UM-1 or D-cells, (preferably alkaline) with the correct polarity as indicated by the " +" and "-" symbols inside the compartment.
AZ 2755 /14 page 6 SPEAKERS RADIO English REMOVABLE LOUDSPEAKERS Taking off the speakers Keep the lever (found on the back corner of the speaker) pressed and slide the speaker upwards. Attaching the speakers Slide the speakers from above into the sleeves on the sides of the cabinet. The speakers will click into position. CONNECTING THE SPEAKERS 1. Connect the right speaker to the R terminal, with the red marked wire to "+" and the black wire to "-". 2.
AZ 2755 /14 RADIO page 7 CD PLAYER 1. Press POWER to on position. 2. Press TUNER source button. – The TUNER indicator lights up. 3. Adjust BAND to select the desired FM/ MW waveband. 4. Tune to a radio station using the tuning knob. – For FM, pull out the telescopic aerial. Incline and turn the aerial. Reduce its length if the signal is too strong (very close to a transmitter). – For MW, the set is provided with a built-in aerial so the telescopic aerial is not needed.
AZ 2755 /14 page 8 CD PLAYER Playing a CD English 1. Press POWER to on position. 2. Press CD source button. – The CD indicator lights up. 3. To open the CD door, press OPEN on the CD door. 4. Insert a CD with the printed side facing up and press the CD door gently to close. 5. Press PLAY•PAUSE 2; on the set to start playback. 6. Adjust the sound using VOLUME 4 , 3 and DBB. 7. To interrupt playback press PLAY•PAUSE 2;. To resume, press PLAY•PAUSE 2; again. 8. To stop CD play, press STOP 9. 9.
AZ 2755 /14 page 9 CD PLAYER English Different play modes : Shuffle and Repeat The SHUFFLE and REPEAT buttons allow you to select various play modes. The modes can be selected or changed during playback. SHUFFLE SHUFFLE - all tracks are played in random order REPEAT - plays the current track continuously REPEAT ALL - repeats the entire CD CD 1. In the stop position or during playback, select your play mode by pressing SHUFFLE or REPEAT once or more until the desired play mode is shown.
CD PLAYER CASSETTE RECORDER English Reviewing your set programme • In the stop position, press and hold down PROG for one second or more. The display shows all your stored track numbers in sequence. – You can also review the programme during playback. • To play your programme press PLAY/PAUSE 2;. PROG CD Erasing a programme You can erase the contents of the memory by: – pressing the CD door open; – pressing TUNER or TAPE source button; – pressing STOP 9 twice during playback/ in stop position.
RECORDING English GENERAL INFORMATION ON RECORDING • Recording is permissible insofar as copyright or other rights of third parties are not infringed. • Recording is only possible on deck 1. • This deck is not suitable for recording on CHROME (IEC II) or METAL (IEC IV) type cassettes. For recording, use NORMAL type cassettes (IEC I) on which the tabs have not been broken. • The best recording level is set automatically. Altering the VOLUME and DBB controls will not affect the recording in progress.
AZ 2755 /14 page 12 RECORDING English Synchro Start CD recording 1. Press CD source button. 2. Insert a CD and if desired, programme track numbers. 3. Press STOP•EJECT 9 / to open the cassette holder. Insert a blank tape. 4. Press the cassette holder shut. 5. Press RECORD 0 to start recording. – Playing of the CD programme starts automatically from the beginning of the programme. It is not necessary to start the CD player separately. 6. For brief interruptions press PAUSE ;.
AZ 2755 /14 page 13 MAINTENANCE English PRECAUTIONS AND SYSTEM MAINTENANCE • Place the set on a hard, flat surface so that the system does not tilt. • Do not expose the set, batteries, CDs or cassettes to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. • Do not cover the set. Adequate ventilation with a minimum gap of 15 cm between the ventilation holes and surrounding surfaces is necessary to prevent heat build-up.
AZ 2755 /14 page 14 TROUBLESHOOTING English If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WARNING: Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this would invalidate the guarantee.