Blu-ray Disc Player User Manual

19
Note
Ensure that the audio format is supported by the disc •
and the connected audio device (amplifier/receiver).
When
• [Bitstream] is selected, interactive audio like
button sound is muted.
[PCM Downsampling]
Set the sampling rate for PCM audio output from
the DIGITAL OUT jack (coaxial/optical).
• [On] - PCM audio is down-sampled at 48kHz.
• [Off] - For BD or DVD recorded in LPCM
without copyright protection, two-channel
audio signals up to 96 kHz are output as LPCM
signals with no conversion.
[Speaker Setup]
Optimize the surround output for the connected
speaker system.
• [Speaker Setup]
Activate the test tone for the speakers and the
subwoofer.
• [Speaker Distance]
Set the delay time for the speakers and the
subwoofer if they are placed closer to the
listening position, so that the sound output
from all speakers reach the listening position at
the same time.
• [Speaker Volume]
Set the volume level of the speakes and the
subwoofer to get the ideal audio balance.
• [Speaker Size]
Set the speaker size for the speakers and •
the subwoofer.
Select • [Large] size for speakers that can
produce low frequency signal below 120
Hz.
Select • [No Speaker] if there is no
speaker connected.
If the front speakers are set to • [Small],
subwoofer setting is [On] and it cannot
be changed.
If the subwoofer is set to • [Off], the
front speakers settings are [Large] and it
cannot be changed.
Tip
The test tone is emitted from the speaker while adjusting •
the volume level.
Allow 1ms setting for every 30cm distance between the
•
speaker and the listening position.
4 Select an option, then press OK.
5 Select a setting, then press OK.
To return to the previous menu, press •
BACK.
To exit the menu, press •
.
[Night Mode]
Make a loud sound level softer and a soft sound
level louder to play the disc at a low volume,
without disturbing other persons.
• [Auto] - Applicable to tracks with Dolby True
HD audio.
• [On] – For quiet viewing at night.
• [Off] – For surround sound with a full dynamic
range.
Note
Applicable only to Dolby encoded DVD-video or BD- •
video.
[HDMI Audio]
Select an HDMI audio output when you connect
this product and the TV/audio device with an HDMI
cable.
• [Bitstream] – Select the best original HD
audio experience (only via an HD audio
compatible receiver).
• [Auto] – Detect and select the best supported
audio format automatically.
[Digital Audio]
Select an audio format for the sound output from
the DIGITAL OUT jack (coaxial/optical).
• [Auto] - Detect and select the best supported
audio format automatically.
• [PCM] - The audio device does not support
multi-channel format. Audio is downmixed to
two-channel sound.
• [Bitstream] - Select the original audio to
experience Dolby or DTS audio (BD-video
special sound effect is disabled).
English
EN