User manual
30 EN
8 Troubleshooting
Warning
Risk of electric shock. Never remove the casing of the •
player.
To keep the warranty valid, never try to repair the
player yourself.
If you have problems using this player, check the
following points before you request service. If you still
have a problem, register your player and get support
at www.philips.com/welcome.
Main unit
No reaction to the remote control.
Connect this player to the power outlet.•
Point the remote control at the IR sensor •
located on the front panel of this player.
Insert the batteries correctly.•
Insert new batteries in the remote control.•
Picture
No picture.
See TV manual for correct video input •
selection. Change the TV channel until you see
the Philips screen.
No picture on HDMI connection.
If this player is connected to an unauthorized •
display device with an HDMI cable, the audio/
video signal may not be output.
Check if the HDMI cable is faulty. Replace a •
new HDMI cable.
On the remote control, press •
and then
press “731” (numeric buttons) to recover
picture display.
No high-definition video signal on the TV.
Make sure that the disc contains high-•
definition video.
Make sure that the TV supports high-•
definition video.
Blu-ray 3D effect is not seen on the TV.
3D option on this player is turned off. Enable •
3D output (see “Adjust settings” > “Video
setup” > [Blu-ray 3D video]).
Ensure that the disc title being played is Blu-ray •
3D compliant.
Ensure that the TV is 3D and HDMI compliant, •
and the TV is set to 3D mode (refer to the
TV’s user manual).
Ensure that the 3D glasses are activated (refer •
to the TV’s user manual).
Accessories supplied
Remote control and batteries•
Power cable•
Quick start guide•
User manual•
CD-ROM built in multi-lingual user manual•
Laser Specification
Laser Type: •
BD Laser Diode: AlGaInN•
DVD Laser Diode: AlGaInP•
CD Laser Diode: AlGaInP•
Wave length: •
BD: 405 +5nm/-5nm•
DVD: 655 +10nm/-10nm•
CD: 790 +10nm/-20nm•
Output power: •
BD: Max. ratings: 20mW•
DVD: Max. ratings: 6mW•
CD: Max. ratings: 7mW•