User manual
16 EN
6 Other features
Set the alarm timer
This unit can be used as an alarm clock. You
can select DISC, USB, or TUNER as the alarm
source.
Note
•
Make sure that you have set the clock correctly.
1 In standby mode, press and hold SLEEP/
TIMER for three seconds.
2 Press / repeatedly to select an
alarm source (DISC, USB,or TUNER)
3 Press SLEEP/TIMER to conrm.
» The hour digits begin to blink.
4 Repeat steps 2-3 to set the hour, minute,
and adjust volume of the alarm.
Note
•
If no button is pressed in 90 seconds, the system exits
timer setting mode automatically.
To activate or deactivate the alarm timer:
• Press SLEEP/TIMER repeatedly to view
the alarm information and activate or
deactivate the alarm.
» If the timer is activated, [TIMER]
(Timer) is displayed.
» If the timer is deactivated, [TIMER
OFF] (timer off) is displayed and
[TIMER](Timer) disappears.
Tip
•
If no DISC or USB is detected, the system will use FM
as the default alarm source.
Set the sleep timer
• Press SLEEP/TIMER to set the number of
minutes before the unit automatically turns
off:
• [SLP 120]
• [SLP 90]
• [SLP 60]
• [SLP 45]
• [SLP 30]
• [SLP 15]
• [SLP OFF]
Tip
•
Sleep timer can only be set when the unit is ‘On’.
Listen from an external
device
You can listen to an external device through this
unit with a 3.5mm audio cable.
1 Press FM/AUDIO IN repeatedly to select
the AUDIO IN source.
2 Connect an audio cable (not supplied)
between:
• the AUDIO IN socket (3.5 mm) on
the unit;
• and the headphone/LINE OUT socket
on an external device.
3 Start to play music on the connected
device (see the device user manual).