operation manual

8 EN
3 Connect
Place the unit
1 Place the unit near the TV.
2 Place the left and right speakers at equal
distance from the TV and at an angle
of approximately 45 degrees from the
listening position.
Note
•
To avoid magnetic interference or unwanted noise,
never place this apparatus and speakers too close to
any radiation devices.
• Place this unit on top of a table.
• Never place this unit in an enclosed cabinet.
• Install this unit near the AC outlet where the AC power
plug can be easily reached.
Connect speakers
Note
•
For optimal sound, use the supplied speakers only.
• Connect only speakers with impedance that is the
same or higher than the supplied speakers. Refer to the
Specicationssectionofthismanual.
1 Holddownthesocketap.
2 Insert the stripped part of the wire
completely.
• Insert the right speaker wires to "R",
left speaker wires to "L".
• Insert the red wires to "+", black wires
to "-".
3 Releasethesocketap.
Connect video cables
You can select the best video connection that
your TV supports.
• Option 1: Connect through a composite
video(CVBS)cable(forastandardTV).
• Option 2: Connect through component
video cables (for a standard TV or
ProgressiveScanTV).
Option 1: Connect through a
composite video cable
• Connect the composite video cable
(supplied)to:
• the VIDEO socket on the back of the
unit.
• the video input socket on the TV.