Always there to help you Register your product and get support at www.philips.
Contents 1 Important Safety 2 Your micro system Introduction What's in the box Overview of the main unit Overview of the remote control 3 Get started Connect speakers Connect power Demonstrate the features Prepare the remote control Set clock Turn on 2 2 4 4 4 5 6 9 9 9 9 9 10 10 5 Listen to the radio 11 11 11 12 12 12 6 Other features 12 12 13 13 13 Tune to a radio station Program radio stations automatically Program radio stations manually Select a preset radio station Show RDS information Set
1 Important • Safety • • This 'bolt of lightning' indicates uninsulated material within the device may cause an electrical shock. For the safety of everyone in your household, please do not remove the covering. The 'exclamation mark' calls attention to features for which you should read the enclosed literature closely to prevent operating and maintenance problems.
• Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. Warning •• Never remove the casing of this device. •• Never lubricate any part of this device. •• Never place this device on other electrical equipment. •• Keep this device away from direct sunlight, naked flames or heat. •• Never look into the laser beam inside this device.
2 Your micro system Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome.
Overview of the main unit m a l k b j i c h d e f g a Bluetooth indicator • Show Bluetooth status. g b h Disc compartment • • Turn the unit on or off. Switch to standby mode or Eco standby mode. c Display panel • Show current status. d SOURCE • Select a source: CD, USB, FM, BT, AUDIO IN. e • i j Headphone socket. • Open/close the disc compartment. • Stop play or erase a program. k VOLUME +/• Adjust volume. l Jack for a USB device. f AUDIO IN • Audio input jack (3.
f VOL +/• Adjust volume. Overview of the remote control g MUTE • Mute or restore volume. a b c FM CD r h SOUND • Enrich sound effect with Digital Sound Control (DSC). q i CLOCK • Set the clock. • View clock information. AUDIO IN PRESET/ALBUM d p e REPEAT f VOL SHUFFLE RDS g MUTE DISPLAY SOUND CLOCK PROG TIMER h i SLEEP o n m l k j j SLEEP/TIMER • Set sleep timer. • Set alarm timer. k PROG • Program tracks. • Program radio stations. • Auto store FM radio stations.
3 Get started Caution •• Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the back of the apparatus. Write the numbers here: Model No. __________________________ Serial No.
3 Close the battery compartment. Switch to standby mode Press again to switch the unit to standby mode. »» The clock (if set) is displayed on the panel. Set clock 1 2 3 4 In standby mode, press and hold CLOCK on the remote control for more than two seconds. »» [24H] or [12H] hour format is displayed. Press / to select [24H] or [12H] hour format. press CLOCK to confirm. »» The hour digits are displayed and begin to blink. Repeat steps 2-3 to set hour and minute.
4 Play USB Play from disc 1 2 3 4 Press CD to select the CD source. Press to open the disc compartment. Insert a disc with printed side facing upward. Press to close the disc compartment. »» Play starts automatically. If not, press . CD Control play / / 3 REPEAT SHUFFLE VOL +/MUTE SOUND Play from USB Note •• Make sure that the USB device contains playable audio content. 1 2 Press USB/AUDIO IN repeatedly to select the USB source. Insert a USB device into the socket. »» Play starts automatically.
Program tracks BT You can program a maximum of 20 tracks. 1 2 3 4 5 Press PROG to activate the program mode. For MP3 tracks, press album. / to select an Press / to select a track, and then press PROG to confirm. Repeat steps 2-3 to program more tracks. • CD FM 3 BTM3160 To erase the program, in the stop position, press . Play from Bluetooth-enabled devices Note •• The effective operation range between the unit and your Bluetooth enabled device is approximately 10 meters (30 feet).
To disconnect the Bluetooth-enabled device: • Deactivate Bluetooth on your device; or • Move the device beyond the communication range. To clear Bluetooth pairing history: • Pressand hold on the main set for 8 seconds. »» The current Bluetooth connection is disconnected. »» After successful clearing, the unit beeps. 5 Listen to the radio Tune to a radio station Tip •• Position the antenna as far as possible from TV, VCR, or other radiation source.
6 Other features Program radio stations manually 1 2 3 4 Set the alarm timer Tune to a radio station. Press PROG, and then press select a number from 1–20. / to Press PROG to confirm. »» The preset number and the frequency of the preset station are displayed. Repeat steps 2-3 to program more stations. This unit can be used as an alarm clock. You can select CD, FM, or USB as alarm source. Note •• Make sure that you have set the clock correctly.
Set the sleep timer Listen through a headphone To set the sleep timer, in turn on mode, press SLEEP/TIMER repeatedly to select a set period of time (in minutes). »» When sleep timer is activated, is displayed. Otherwise, disappears. Plug a headphone (not supplied) into the socket on front of this product. Listen to an external device You can listen to an external device through this unit with an MP3 link cable. 1 2 3 Press USB/AUDIO IN repeatedly to select AUDIO IN source.
7 Product information Note •• Product information is subject to change without prior notice. USB Direct Version USB 5 V Power Amplifier Signal to Noise Ratio Total Harmonic Distortion Aux Input 150 W 60 Hz - 16 kHz; ±3 dB ≥70 dBA <1% 600 mV RMS Speakers Speaker Impedance Speaker Driver Sensitivity 6 ohm 3.5" woofer + 20 mm tweeter >84 dB/m/W Bluetooth Bluetooth version Frequency band Range V2.1 + EDR 2.4GHz ~ 2.
USB playability information Compatible USB devices: •• USB flash memory (USB2.0 or USB1.1) •• USB flash players (USB2.0 or USB1.1) •• memory cards (requires an additional card reader to work with this unit) Supported formats: •• USB or memory file format: FAT12, FAT16, FAT32 (sector size: 512 bytes) •• MP3 bit rate (data rate): 32-320 Kbps and variable bit rate •• Directory nesting up to a maximum of 8 levels •• Number of albums/ folders: maximum 99 •• Number of tracks/titles: maximum 999 •• ID3 tag v2.
•• Aim the remote control directly at the sensor on the front of the unit. No disc detected •• Insert a disc. •• Make sure that the disc is inserted with printed side facing upward. •• Wait until the moisture condensation at the lens has cleared. •• Replace or clean the disc. •• Use a finalized CD or correct format disc. Cannot display some files in USB device •• The number of folders or files in the USB device has exceeded a certain limit. This phenomenon is not a malfunction.
9 Notice Your product contains batteries covered by the European Directive 2006/66/EC, which cannot be disposed with normal household waste.Please inform yourself about the local rules on separate collection of batteries because correct disposal helps to prevent negative consequences for the environmental and human health. This product complies with the requirement of the 1999/5/EC directive.
Specifications are subject to change without notice © 2013 Koninklijke Philips Electronics N.V. All rights reserved. BTM3160_12_UM_V1.