User manual
8
the power socket on the wall.•
Install the handset
Caution
Risk of explosion! Keep batteries away from •
heat, sunshine or re. Never discard batteries
in re.
Use only the supplied batteries. •
Risk of decreased battery life! Never mix •
different brands or types of batteries.
Warning
Check the battery polarity when inserting in •
the battery compartment. Incorrect polarity
may damage the product.
The batteries are pre-installed in the handset.
Pull the battery tape off from the battery door
before charging.
3 Get started
Caution
Ensure you have read the safety instructions in •
the “Important” section before you connect
and install your handset.
Connect the base station
Warning
Risk of product damage! Ensure that the •
power supply voltage corresponds to the
voltage printed on the back or the underside
of the phone.
Use only the supplied power adapter to charge •
the batteries.
Note
If you subscribe to the digital subscriber line •
(DSL) high speed internet service through
your telephone line, ensure you install a DSL
lter between the telephone line cord and
the power socket.. The lter prevents noise
and caller ID problems caused by the DSL
interference. For more information on the DSL
lters, contact your DSL service provider.
The type plate is located on the bottom of the •
base station.
1 Connect each end of the power adapter
to:
the DC input jack at the bottom of •
the base station;
the power socket on the wall.•
2 Connect each end of the line cord to:
the telephone socket at the bottom •
of the base station;
the telephone socket on the wall.•
3 Connect each end of the power adapter
to (for multi handset version only):
the DC input jack at the bottom of •
the extra handset charger.
EN