CONTROLS AND CONNECTIONS 2 3 4 56 CDR 785 7 8 9 0 ! @ # $ % ^ & English 1 AUDIO CD RECORDER ON/OFF REPEAT CD TEXT SHUFFLE DISPLAY STEP CD 1 STOP TEXT TOTAL TRACK TIME TOTAL REM CD TEXT EDITING REC TRACK TIME RECORD 1 CD-CHANGE 2 3 4 5 6 CD RW CD 3 7 8 CD RW RECORD RECORD IN IN PROGRESS PROGRESS OPEN/CLOSE TEXT PROG TRACK EDIT CDR 9 10 11 12 13 14 15 16 17 18 19 20 + COMPILE COMPILE DISC DISC ALL ALL PROGRAM PROGRAM SHUFFLE SHUFFLE REPEAT REPEAT TRACK TRACK EDIT EDIT JOG
CONTROLS AND CONNECTIONS English L R OPTICAL IN IN OUT ANALOG IN OUT DIGITAL AC MAINS 1 Connections at the back 1 Connection to power 2 ANALOG IN.............connects to the line output of a tape deck, amplifier or other analogue source 3 ANALOG OUT CDR & CD ..................................connects to the line input of an amplifier. (left and right) 4 DIGITAL IN..............connects to the digital coaxial output of an external CD player 5 DIGITAL OUT CDR & CD ..................................
INSTALLATION English Connections general Analog connections For playback on the CD recorder from the CD changer deck the following outputs are present: – Digital coaxial output (CD & CD-R) – Analog output (CD & CD-R) We advise you to connect these to the TAPE or CD-R input on your amplifier. This connection must be made for playback on the CD recorder deck as well as the CD changer deck (cord 2). Cord 1 is only required if you want to make recordings from an external analog source.
Digital coaxial connections Digital optical connections This connection is required if you want to make recordings from an external CD player with a digital coaxial output. This connection is required if you want to make recordings from an external CD player with a digital optical output.
INSTALLATION English Power supply/Mains Inserting batteries in the remote control AC MAINS The type plate is located on the rear of the set. 1 Check whether the power voltage as shown on the type plate corresponds to your local power voltage. If it does not, consult your dealer or service organisation. 2 Make sure all connections have been made before switching on the AC power supply. 2x AA, LR6, UM-3 / 1,5 V 3 Connect the power cord supplied to AC POWER ~ and to the wall outlet.