Always there to help you Register your product and get support at www.philips.
Contents 1 Important 2 2 Your car stereo speakers 2 3 Installation 3 4 Product information 7 5 Troubleshooting 8 Safety Notice Introduction What’s in the box Option 1: Mount on door (front or rear) Option 2: Mount on rear tray 2 2 3 3 4 7 EN 1
1 Important Safety • • • • • Read and understand all instructions before you use the apparatus. If damage is caused by failure to follow instructions, the warranty does not apply. Use only the supplied mounting hardware for a safe and secure installation. Do not continuously use the speaker system beyond the peak power handling capacity. Keep credit cards, watches, recorded tapes etc. with magnetic coding away from the speaker system to prevent damage caused by the magnets in the speakers.
Introduction With the speakers, you can enjoy high power music with vivid sound. What’s in the box Check and identify the contents of your package: a Speakers (x2) b Grille net + Frame (x2) c Speaker wire (x2) d Screw (x8) e Shrapnel (x8) 3 a b d e c Installation A depth of at least 46mm is required to mount the speaker. Measure the depth of the area where you are to mount the speaker, and ensure that the speaker does not obstruct any other components of the car.
Option 1: Mount on door (front or rear) You can mount the speakers on the front/rear door of your car. Note •• Make sure that nothing obstructs around the mounting location of the door. •• A hole for mounting may already be cut out of the inner panel of the door (front or rear). In this case, you need to modify the board only. •• Ensure that the speaker terminals, frame or magnet do not interfere with any inner parts, such as the window mechanism in the door (when you open or close the window), etc.
5 Cut out the marked area and drill the bolt holes. 6 Remove the grille net. 7 Strip the speaker wires and connect them to the amplifier.
Note •• Match the “left”, “right”, “+” and “-” terminals correctly. Revised polarity may degrade sound quality. •• Two 4-ohm speakers, wired in stereo, present a 8 ohm load to each channel of the amplifier. Most two channel amplifiers work well in this configuration. However, if two 4-ohm speakers, wired in parallel to a bridged two -channel amplifier, present a 2-ohm mono load to the amplifier.
Option 2: Mount on rear tray You can also mount the speakers into the surface of the rear tray. Follow the steps in section “Option 1: Mount in door” to mount the speakers into the rear tray: 4 Product information Note •• Product information is subject to change without prior notice. Model CSP530 CSP630 Speaker type 13 cm, 3-way coaxial speaker 16.
5 Troubleshooting To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, go to the web site (www.philips.com/welcome). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available.
2013 © WOOX Innovations Limited. All rights reserved. This product was brought to the market by WOOX Innovations Limited or one of its affiliates, further referred to in this document as WOOX Innovations, and is the manufacturer of the product. WOOX Innovations is the warrantor in relation to the product with which this booklet was packaged. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. CSP530\630_00_UM_V2.
