Firmware-Upgrade Software

Software Update Instructions

To get the best features and support, update your product with the latest software.

Note:

• This software update can be completed without connecting TV through HDMI but you have to follow the local

display on the soundbar carefully.

Check software version

In HDMI ARC source mode, press TREBLE -, BASS - and VOLUME - on the remote control.

Check on Sound bar local display for version info

1) Main Version

2) RISC version

3) TX version

4) RX version

5) Repeater version (if applicable)

Update software via USB

Check the latest software version on www.philips.com/support.

• Search for your model and click on "Software and drivers".

Download the software into a USB storage device.

a. Unzip the downloaded file, and make sure that the unzipped file is named the following:

CSS5530 - "CSS5530.BIN".

CSS5330 - "CSS5330.BIN".

b Put the related software file in theroot directory of the USB storage device.

Connect the USB storage device to the (USB) connector on this product.

Switch this product to the HDMI ARC source, and switch your TV to the HDMI source

On the remote control, within 6 seconds press MUTE twice, and VOLUME+ once, then hold down SOUND

»» If an upgrade media is detected, on Soundbar local display, message “UPG” will be blinking

»» If an upgrade media is not detected, an error message is displayed on the local display. Make sure that the

latest software of this product is put in the USB storage device.

Press MUTE to start the update.

On Soundbar local display, message “UPG” will be shown and not blinking,

Wait until the update is completed.

On Soundbar local display, it will show “DONE” when update is completed

»» If the update is complete, the Soundbar will automatically turn off and on again.

PAGE 1
Software Update Instructions To get the best features and support, update your product with the latest software. Note: • This software update can be completed without connecting TV through HDMI but you have to follow the local display on the soundbar carefully. Check software version In HDMI ARC source mode, press TREBLE -, BASS - and VOLUME - on the remote control.
PAGE 2
8 The update will be completed within 10 minutes If you cannot complete the update at step 7, please power off the device and unplug the USB storage device. Then start from steps 3 -7 again. 9 Check the SW version to ensure the SW upgrade is done successfully Caution! Do not turn off the power or remove the USB storage device when the software update is in progress because you might damage this player. Note It is recommended that you perform a factory reset after software upgrade.