Register your product and get support at www.philips.
Important safety instructions Warning • The Electrical network is classified as hazardous. The only way to power down the charger is to unplug the power supply from the electrical outlet. Ensure that the electrical outlet is always easily accessible. • Refer to safety information before using the product. • Hereby, Gibson Innovations declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU.
1 Overview In call Enter the option menu. Change the sound profile. Adjust the volume. Standby Access the main menu. Access the redial list. Phonebook Recall (network dependent). Call log End calls. Enter a pause (press and hold). Turn the speaker on/off. Make and receive calls. Mute/unmute the microphone. In menu Confirm / Select / Enter the option menu. Cancel / back Up / down Exit menu. Switch the handset on or off (press and hold). Make intercom call (press and hold).
2 Connect 1 D455 2 1 2 D450 3 Multi-handset version only.
3 Get started Insert batteries Charge your phone Configure your phone 1 When using your phone for the first time, you see a welcome message (country dependent). 2 Set the country and language if prompted. 3 Set the date and time. • If the time is in 12-hour format, press / to select [am] or [pm] (country dependent).
4 Enjoy Phonebook Add record 1 Press [Menu]. 2 Select [Phonebook] > [Add new]. 3 Follow on-screen instructions. Call from the phonebook 1 Press . 2 Select a record and press . 3 Follow on-screen instructions. Direct access memory You have up to 2 direct access memories (keys 1 and 2). To dial the saved phone number automatically, press and hold on the keys in standby mode.
5 Learn more Silent mode Sets time during which the phone will not ring. [Phone setup] > [Sounds] > [Silent mode] MySound Customizes the sound of voices to your liking. [Phone setup] > [Sounds] > [MySound] Eco/ECO+ mode Reduces transmission power and radiation (causes 2 seconds ring delay, 50% shorter standby time). [Phone setup] > [Eco mode]/[ECO+ mode] Call barring Prevents unwanted outgoing calls to selected numbers.
Technical data Battery Philips: 2 x AAA NiMH 1.2 V Rechargeable 550 mAh batteries Use only the supplied batteries.
Frequently asked questions No signal bar is displayed on the screen. • The handset is out of range. Move it closer to the base station. • If the handset displays [Register your Handset], register your handset. (See the section on “Register additional handsets”). If I fail to pair (register) the additional handsets to the base station, what do I do? > [Services] Your base memory is full. Access > [Unregister] to unregister the unused handsets and try again.
www.philips.com/support To access the user instructions online, use the reference model number written on the product label at the bottom of the base station.
2017 © Gibson Innovations Limited. All rights reserved. This symbol on a product means that the product is covered by European Directive 2012/19/EU. This product has been manufactured by, and is sold under the responsibility of Gibson Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license from Koninklijke Philips N.V. ums_D450/455 05_en_v4.
