Register your product and get support at www.philips.
(in standby mode) (in standby mode) Important notes for users in the U.K. Mains fuse This information applies only to products with a UK mains plug. This product is fitted with an approved nonmolded plug. If you replace the fuse, use one with: the ratings shown on the plug, a BS 1362 approval, and the ASTA approval mark. Contact your dealer if you are not sure about what type of fuse to use. Caution: To confor m with the EMC directive (2004/108/EC), do not detach the plug from the power cord.
1 2 Important 4 Safety Notice 4 5 Your Micro Hi-Fi System 6 Introduction What’s in the box Overview of the main unit Overview of the remote control 6 6 7 8 8 Other features 19 Set the alarm timer Set the sleep timer 19 20 Register your product Perform the upgrade 20 21 10 Product information 3 Before use 10 Place the product 10 Connect 10 Install/replace the batteries of remote control 12 4 5 6 7 Get started 13 Turn on S
1 Important Read and understand all instructions before you use this product. If damage is caused by failure to follow the instructions, the warranty does not apply. Safety Risk of electric shock! Never expose the product and accessories to rain or water. Never place liquid containers, such as vases, near the product. If liquids are split on or into the product, disconnect it from the power outlet immediately. Contact Philips Consumer Care to have the product checked before use.
Listen for reasonable periods of time: Prolonged exposure to sound, even at normally ‘safe’ levels, can also cause hearing loss. Be sure to use your equipment reasonably and take appropriate breaks. Be sure to observe the following guidelines when using your headphones. Listen at reasonable volumes for reasonable periods of time. Be careful not to adjust the volume as your hearing adapts. Do not turn up the volume so high that you can’t hear what’s around you.
& # # recordings, may be an infringement of copyrights and constitute a criminal offence. This equipment should not be used for such purposes. “Made for iPod,” “Made for iPhone,” and “Made for iPad” mean that an electronic accessory & iPod, iPhone, or iPad, respectively, and has Apple performance standards.
Eng l i s h Overview of the main unit m a l b k c d e j f g i h a h / Skip to the previous/next track. Select a preset radio station. b SOURCE Select a source. c d Turn on this product. Switch to eco-power standby mode or normal standby mode. /OK Start, pause, or resume play. ; <%> ?@ # menu option. In FM mode and with no menu option displayed, switch the sound mode between stereo and monophonic. e Display panel f Headphone socket.
a Overview of the remote control a y b x c w v d u e t s f g r h q i Turn on this product. Switch to the eco-power standby mode or normal standby mode. b DIM Adjust the brightness of display panel. Press and hold to turn on or off the LED light at the bottom of the unit and at the volume knob. c SCAN Search for available FM or DAB radio stations. d SLEEP Set the sleep timer. e j p k o l m n : Skip to the previous/next album.
/ Search backward or forward fast. Tune to an FM radio station. Select a preset DAB radio station. In the DAB or FM mode, navigate through the menu. j TREBLE Activate the adjustment of treble level. k BASS Activate the adjustment of bass level. l Numeric keypad Enter numbers. Enter the track number to select a track directly. Enter the sequence number to select a preset radio station. m SHIFT Switch the entry of a one, two or three-digit number by the numeric keypad.
3 Before use Connect speakers Note Place the product Insert the stripped portion of each speaker wire into the socket completely. For the optimal sound, use the supplied speakers only. Connect speakers only with impedance that is the same or higher than that of the supplied speakers. Two speaker cables are supplied. Each speaker cable has two strands.
Eng l i s h Route audio to other devices You can route the audio from this product to other devices. Connect an analogue stereo system Note Connect the control cable correctly and tightly to avoid abnormal performance. Connect the DAB/FM antenna Tip Connect the audio cable to: the LINE OUT L/R jacks on this product. the audio input jacks on the device. Make sure that you have connected and fully extended the antenna before your connect the power supply.
Route audio input through the MP3 LINK socket Install/replace the batteries of remote control Note Risk of explosion! Keep batteries away from heat, $ $ Remove the battery if the remote control is not to be used for an extended period of time. Connect an MP3 Link cable to: the MP3 LINK socket on this product. the headphone socket on the external device (for example, MP3 player).
Set clock 1 In the normal standby mode, press and hold CLOCK to activate the clock setting mode. » [CLOCK SET] scrolls on the display panel, and then [CLOCK 24HR] (24hour time format) is displayed with “24” blinking. 2 Press VOL +/- to select [CLOCK 24HR] or [CLOCK 12HR] (12-hour time format), and then press CLOCK $ » The hour digits begin to blink. 3 4 Press VOL +/- to set the hour. 5 6 Press VOL +/- to set the minute.
Adjust brightness of display panel Press DIM repeatedly to select different brightness levels. 5 Play Play a disc Caution Turn on or off LED light Risk of damage to the player! During play, never move the unit. In the working mode, press and hold DIM to turn on or off the LED light at the bottom of the unit and at the volume knob. Never put any object other than a disc into the disc compartment. Never look at the laser beam inside the player.
Basic operations Buttons Actions Start, pause, or resume the play. Stop the play. G J $ Press and hold to search backward/forward fast. Select a play mode: normal play, # ! $ Display the current status and media information. Note / Philips does not guarantee compatibility with all USB devices. / NTFS (New Technology File System) data format is not supported.
Adjust sound During play, you can adjust the volume level and sound effect through following operations. Buttons VOL +/- Actions Press to increase or decrease the volume level. Press to mute or restore the sound. LOUDNESS Press to turn on or off the automatic loudness control. BASS Press BASS, and then press VOL +/- to increase or decrease the bass level. TREBLE Press TREBLE, and then press VOL +/- to increase or decrease the treble level.
Charge the iPod/iPhone/iPad The docked iPod/iPhone/iPad begins to charge as soon as this product is connected to AC power. Note iPod with color display, iPod classic, and iPod with video are not compatible with dock charging. Remove the iPod/iPhone/iPad 1 2 Release the dock on the top panel. 1 Pull the iPod/iPhone/iPad out of the dock. 2 Hide the dock. Connect the iPod/iPhone/iPad to the dock. Listen to the iPhone/iPod/ iPad 1 Press DOCK to select iPhone/iPod/iPad source.
7 Listen to radio Basic operations Follow the instructions below for more functions. Note Make sure that you have correctly connected and fully extended the antenna. You can program a maximum of 30 DAB radio stations and 30 FM radio stations. Check with local retailer or go to www.WorldDAB.org for the applicable DAB radio frequencies in your area. Refer to “Product information” > “RDS program types” for more information about RDS radio stations.
When you listen to radio, you can access the menu for control options. 1 2 Press MENU or . » FM mode: [SCAN SETTINGS] is displayed. » DAB mode: [STATION] is displayed. Press / or / to select a menu option, and then press OK or the option or enter the lower-level menu.
Note The alarm timer is not available in MP3 LINK mode. If other alarm sources are unavailable, this product switches to FM mode automatically. Set the sleep timer 9 Upgrade the firmware Note Power supply must not be interrupted during the upgrade. This unit can switch to standby automatically after a set period of time. In the working mode, press SLEEP repeatedly to select a set period of time (in minutes). To deactivate the sleep timer, press SLEEP repeatedly until [SLEEP--OFF] is displayed.
10 Product information Eng l i s h % version Follow the steps to check the current version $ 1 2 3 4 5 6 Press DAB/FM to switch to radio mode. Press MENU or to access the menu. Press / or [SYSTEM]. / to select / to select [SW Press OK or Press / VER]. or Product information is subject to change without prior notice. . Press OK or .
DAB Tuner Tuning Range Sensitivity 174–240 MHz (Band III) > 90 dBf Speakers Speaker Impedance Speaker Driver Sensitivity 6ohm 13 cm woofer + 2.5 cm Dome tweeter >86dB/m/W ± 4dB/m/W General information AC power Operation Power Consumption Power Consumption in Eco-power Standby Mode Headphone output USB Direct Dimensions - Main Unit (W x H x D) - Speaker Box (W x H x D) Weight - With Packing - Main Unit - Speaker Box 220 - 240 V~, 50/60 Hz 45 W < 0.5 W 2X15 mW, 32 Ohm version 2.
NO TYPE NEWS AFFAIRS INFO SPORT EDUCATE DRAMA CULTURE SCIENCE VARIED POP M ROCK M MOR M LIGHT M CLASSICS OTHER M WEATHER FINANCE CHILDREN No RDS programme type News services Politics and current affairs Special information programs Sports Education and advanced training Radio plays and literature Culture, religion and society Science Entertainment programs Pop music Rock music Light music Light classical music Classical music Special music programs Weather Finance Children’s programs SOCIAL RELIGION PHONE
Before you press any function button, select the correct source with the remote control instead of the main unit. Make sure that you connect the control cable correctly and tightly. Reduce the distance between the remote control and the main unit. Insert each battery with its polarities (+/– signs) aligned as indicated. Replace the batteries. Aim the remote control directly at the sensor on the front of the main unit. No disc Insert a disc.
© 2011 Koninklijke Philips Electronics N.V. All rights reserved. DCB8000_10_UM_V1.
