Register your product and get support at www.philips.
1 2 3 4 5 6 7 Important 4 Know these safety symbols Hearing Safety 4 5 Your Micro System 6 Introduction What’s in the box Overview of the main unit Overview of the remote control 6 6 7 8 Get started 9 Placement Connect FM antenna Prepare the remote control Connect power Store FM radio stations automatically Set clock Turn on 9 9 10 10 10 11 11 Play 12 Play disc Play from USB Play from iPod/iPhone/iPad Play options Adjust sound Display different information 12 12 12 13 14 14 Listen to
1 Important & & & & & & & & & & & & & & & 4 Read these instructions. Follow all instructions. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or ) * + produce heat. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the unit.
English Hearing Safety Danger & To avoid hearing damage, limit the time you use the headphones at high volume and set the volume to a safe level. The louder the volume, the shorter is the safe listening time. Be sure to observe the following guidelines when using your headphones. & Listen at reasonable volumes for reasonable periods of time. & Be careful not to adjust the volume continuously upwards as your hearing adapts. & Do not turn up the volume so high that you can’t hear what’s around you.
2 Your Micro System Congratulations on your purchase, and # V X ; ! support that Philips offers, register your product at www.philips.com/welcome.
English Overview of the main unit a b g MP3-LINK c d h i e j SOURCE OK / MENU / VOLUME VOLUME f m n k l FM ANT MICRO MUSIC SYSTEM DCM2060 o DC IN 12 V 3A DOC K for & Connect USB device. f OK/ & [ ' & Start/pause play. & Headphone socket. g MP3-LINK & Connect an external audio device. & & Turn the unit on/off. Switch to standby mode. h a b c d SOURCE & Select a source: CD, FM, USB, Dock, or MP3 LINK. e / & & & & Skip to the previous/next track.
m Display panel & Show play information. a n Disc tray Turn the unit on/off. Switch to standby mode. & Mute/restore sound. b o DOCK for iPod/iPhone/iPad c CD & Select CD source. Overview of the remote control d / & & & & a Skip to the previous/next track. Search within a track/disc. Tune to radio stations. Adjust time. e USB/MP3 LINK & Select USB/MP3 link source.
o MENU/ & Access iPod/iPhone/iPad menu. & Stop play or erase a program. p DOCK & Select iPod/iPhone/iPad source. q OK & [ r Caution & Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in $ ' ' Placement / & & 3 Get started English n REPEAT/SHUFFLE & Play a track or all tracks repeatedly. & Play tracks in current album repeatedly.
Prepare the remote control Connect power Caution Caution & Risk of explosion! Keep batteries away from heat, & & ' = ! ' Risk of decreased battery life! Never mix different brands or types of batteries. Risk of product damage! When the remote control is not used for long periods, remove the batteries. & Risk of product damage! Ensure that the power supply & & voltage corresponds to the voltage printed on the back or the underside of the unit.
Press and hold for 3 seconds to start full scan. » The unit automatically stores FM radio # * * ! station. Turn on English 2 Press . » The unit switches to the last selected source. Note Tip & To exit storing mode, press or . & To select a source, press SOURCE repeatedly or the source selection buttons on the remote control. Switch to standby mode Set clock 1 In standby mode, press and hold CLOCK SET on the remote control for two seconds.
4 Play Play from iPod/iPhone/iPad Play disc You can enjoy audio from iPod/iPhone/iPad through this unit. 1 2 3 4 Press to open the disc compartment. Insert a disc with the printed side facing up. Press to close the disc compartment. Press CD on the remote control to select the disc source. » [Reading] ) *+ ! moment, then CD starts playing automatically. If not, press . Play from USB Note & Make sure that the USB device contains playable audio content.
Push DOCK for iPod/iPhone/iPad to open the dock compartment. 2 Place the rubber pad into the dock compartment as indicated. 3 Place an iPad or iPad 2 into the dock. When the unit is connected to power, the docked iPod/iPhone/iPad begins to charge. English 1 Tip & For certain iPod models, it may take up to a minute before the charging indication appears. Play options Pause/resume play Listen to the iPod/iPhone/iPad 1 Make sure that the iPod/iPhone/iPad is loaded correctly.
2 Release to resume normal play. Display different information Program tracks You can program a maximum of 20 tracks. 1 In CD/USB mode, press to stop playback, then press PROG to activate the programming mode. » [PROG] ) * + ; ' 2 For MP3/WMA tracks, press select an album. 3 Press PROG 4 Repeat steps 2 to 3 to program more tracks. 5 Press to play the programmed tracks. » During play, [PROG ) * + displayed.
Tune to FM radio stations Note & Position the antenna as far as possible from TV, VCR, or other radiation source. & Ensure that you have connected and fully extended the supplied FM antenna. 1 2 Program FM radio stations manually English 5 Listen to FM radio 1 2 In tuner mode, tune to an FM radio station. 3 Press / number. 4 5 Press PROG * Press PROG to activate programming mode. » [PROG] ) * + ! ' repeatedly to select a channel ' Repeat steps 1-4 to store other FM stations.
Select stereo/mono broadcast Note & Stereo broadcast is the default setting for tuner mode. & For stations with weak signals: to improve the reception, change to monaural sound. 6 Other features Set the alarm timer This unit can be used as an alarm timer. You can select CD, FM tuner, iPod/iPhone/iPad, or USB as alarm source. In FM tuner mode, press OK to switch between mono and stereo broadcast. Note & Make sure that you have set the clock correctly.
3 Start to play the external device (see the = +' English To activate or deactivate the alarm timer, In standby mode, press TIMER repeatedly to activate or deactivate the alarm. » appears when the timer is activated. Listen through the headphone Tip & If CD/USB/iPod source is selected, but no disc is Plug a headphone into the socket on the unit. inserted or no USB/ipod/iPhone/iPad connected, the unit switches to the tuner source automatically.
7 Product information Note & Product information is subject to change without prior notice. AC power 2 X 10 W RMS 80 Hz - 16 kHz, ± 3 dB \ 0.5 V RMS 20 kohm Disc Laser Type Disc Diameter Support Disc Audio DAC Total Harmonic Distortion $ ; S/N Ratio Tuning range Tuning grid Sensitivity - Mono, 26dB S/N Ratio - Stereo, 46dB S/N Ratio Search selectivity Total harmonic distortion Signal to noise ratio Number of presets 87.
& & & & Directory nesting up to a maximum of 8 levels Number of albums/ folders: maximum 99 Number of tracks/titles: maximum 999 ID3 tag v2.0 or later File name in Unicode UTF8 (maximum * !; + Unsupported formats: & Empty albums: an empty album is an album GV}< G % is not be shown in the display. & ' % )' + GV} # ' * not played.
Replace the battery. Aim the remote control directly at the sensor on the front of the unit. 9 Notice No disc detected Insert a disc. Check if the disc is inserted upside down. Wait until the moisture condensation at the lens has cleared. Replace or clean the disc.
$ purposes. ! English cannot be disposed with normal household waste.Please inform yourself about the local rules on separate collection of batteries because correct disposal helps to prevent * = $ = and human health. This apparatus includes this label: Environmental information All unnecessary packaging has been omitted.
© 2011 Koninklijke Philips Electronics N.V. All rights reserved. DCM2060_12_CCR_V2.
