Operation Manual
GB8
WelcomeEye Connect / Touch / 09/17
4. Installing the main or additional
intercom panel
Warning: The product must not be connected to the power supply before wiring is complete.
DES 9900 VDP
5 1 0 0 6 3
1
2
3
4
5
6
1 2
7
8
1
2
1
2
DES 9900 VDP
5 1 0 0 6 3
Made in P.R.C
CFI Extel
ZI de Fétan, 01600 Trévoux
FRANCE
IP44
20V 110mA
RFID 125kHz
1m60
1
1
2
2
1 2
4
7
5
3
6
8 9
1 - Remove the tamper-resistant screw from the intercom panel.
2 - Tip the intercom panel cover forward.
3 – The intercom’s lens should be approximately 1.60m above the ground.
4 – Mark the locations.
5 - Drill.
6 - Use pegs adapted to the nature of the support (the screws supplied are suitable for
solid walls).
7 – Connect the two wires from the monitor and, if necessary, connect the electric strike
plate and the gate (see section 1. Wiring). Con gure the switches at the back of the
intercom panel (see section 2. Con guring the intercom).
8 – Insert the screws and re t the two caps concealing the retaining screws.
Note: screw through the black covers on the back of the intercom panel – do not remove
them.