Register your product and get support at www.philips.
Contents 1 Important 3 2 Your Docking Speaker 4 Introduction What’s in the box Overview of the main unit 3 Get started 5 Connect power Turn on 4 Play 5 6 6 Play from iPod/iPhone Play from an external device Adjust volume 4 4 4 General information 6 8 9 9 6 Troubleshooting 10 7 Notice 10 Disposal of your old product and batteries 10 EN 2
1 Important Read these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or produce heat. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
2 Your Docking Speaker Overview of the main unit Congratulations on your purchase, and ' ) * 7 ! support that Philips offers, register your product at www.philips.com/welcome. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the bottom of the apparatus. Write the numbers here: Model No. __________________________ Serial No.
3 Get started Option 2: Battery power Caution Always follow the instructions in this chapter in sequence. Risk of explosion! Keep batteries away from heat, $ > ! $ Remove batteries if they are exhausted or will not be used for a long time. Batteries contain chemical substances, so they should be disposed of properly. Connect power This docking speaker can be powered by either AC power or batteries. 1 2 Open the battery compartment.
Turn on 4 Play Press to turn the docking speaker on. » The / LED indicators light up. Play from iPod/iPhone You can enjoy audio from your iPod/iPhone through this docking speaker.
3 ] @ # ' ! " install DockStudio app on your iPod/ iPhone. 4 Tap [Yes] request. 5 Follow the on-screen instructions to complete the installation. J ' ! # DockStudio app will search for it automatically and ask you to download it. Note Make sure that your iPod/iPhone is inserted in the docking speaker and connected to the Internet. 6 7 J ' ' # OK.
1 2 Insert the iPod/iPhone in the dock. Press to switch to standby mode. » The LED indicators light off. 3 Connect your docking speaker and PC with a USB cable. 4 Launch iTunes to synchronize your docking speaker with PC. » The docked iPod/iPhone is synchronized with PC successfully through the iTunes. Note Due to different materials and product techniques, some USB cables may not work with this device. Note Do not disconnect power or undock the iPod/iPhone during the updating process.
Adjust volume To adjust volume: Press +/- on your docking speaker; or Adjust the volume control of your iPod/ iPhone or external device. 5 Specifications Rated Output Power 2 X 5 W RMS General information Power supply - AC Power Tip If the docking speaker is powered by batteries, the volume is lower than that by AC supply. 9 EN - Battery Operation Power Consumption Standby Power Consumption Max.
6 Troubleshooting Warning Never remove the casing of this apparatus. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site '''$ $ $ Philips, ensure that the apparatus is nearby and the model number and serial number are available.
Please visit www.recycle.philips.com for additional information on a recycling center in your area. Environmental information All unnecessary packaging has been omitted. We have tried to make the packaging easy to ! ! % # ! ! # $ Your system consists of materials which can be recycled and reused if disassembled by a specialized company.
Specifications are subject to change without notice © 2012 Koninklijke Philips Electronics N.V. All rights reserved.