Register your product and get support at www.philips.
Contents 1 Important 3 2 Your Docking Speaker 4 Introduction What’s in the box Overview of the main unit 3 Get started 5 Connect power Turn on 4 Play 5 5 6 Play from iPod/iPhone Play from an external device Adjust volume 4 4 4 General information 6 8 9 9 6 Troubleshooting 10 7 Notice 10 EN 2
1 Important Read these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or produce heat. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
2 Your Docking Speaker Overview of the main unit Congratulations on your purchase, and = > ? < ! support that Philips offers, register your product at www.philips.com/welcome. a b c Introduction d With this docking speaker, you can enjoy audio from the iPod/iPhone, and other external audio devices; and synchronize the iPod/iPhone with your computer through USB socket.
3 Get started Always follow the instructions in this chapter in sequence. 1 2 Open the battery compartment. 3 Close the battery compartment. Insert 4 x 1.5V AA batteries with correct X Y $ Connect power This docking speaker can be powered by either AC power or batteries. Option 1: AC power Caution Risk of product damage! Make sure that the power supply voltage matches the voltage printed on the bottom of the unit.
Switch to standby mode The docking speaker switches to standby mode in the following situation: Press again; The speaker is idle for 15 minutes when powered by AC supply. The iPod/iPhone or external audio device is disconnected when the speaker is operated on batteries. » The / LED indicators light off. 4 Play Play from iPod/iPhone You can enjoy audio from your iPod/iPhone through this docking speaker. Compatible iPod/iPhone The docking speaker supports the following iPod and iPhone models: Made for.
3 \ Y # = ! " install DockStudio app on your iPod/ iPhone. 4 Tap [Yes] request. 5 Follow the on-screen instructions to complete the installation. 6 7 Launch the app after the installation. Play audio on your iPod/iPhone. » Audio comes out through this docking speaker.
1 2 Insert the iPod/iPhone in the dock. Press to switch to standby mode. » The LED indicators light off. 3 Connect your docking speaker and PC with a USB cable. 4 Launch iTunes to synchronize your docking speaker with PC. » The docked iPod/iPhone is synchronized with PC successfully through the iTunes. Note Due to different materials and product techniques, some USB cables may not work with this device. Note Do not disconnect power or undock the iPod/iPhone during the updating process.
Adjust volume To adjust volume: Press +/- on your docking speaker; or Adjust the volume control of your iPod/ iPhone or external device. 5 Specifications Note Product information is subject to change without prior notice. Rated Output Power 2 X 5 W RMS General information Power supply - AC Power Tip If the docking speaker is powered by batteries, the volume is lower than that by AC supply. 9 EN - Battery Operation Power Consumption Standby Power Consumption Max.
6 Troubleshooting Warning Never remove the casing of this apparatus. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site ===$ $ = $ ' Philips, ensure that the apparatus is nearby and the model number and serial number are available.
is covered by the European Directive 2002/96/ EC. Please inform yourself about the local separate collection system for electrical and electronic products. Please act according to your local rules and do not dispose of your old products with your normal household waste. Correct disposal of your old product helps to prevent potential negative consequences for the environment and human health.
Specifications are subject to change without notice © 2012 Koninklijke Philips Electronics N.V. All rights reserved. DS3110_12_UM_V1.