Owner's Manual
12 Hookups (cont’d)
Connecting to a TV Only
TV has Component Video In Jacks (green,blue, and red)
Back of TV
(example only)
LEFT AUDIO IN
RIGHT AUDIO IN
Pr/Cr
Y
Pb/Cb
LEFT AUDIO IN
RIGHT AUDIO IN
Pr/Cr
Y
Pb/Cb
1
2
3
Y
Pb
Pr
1
Connect the DVD Player’s green,blue, and red Y Pb Pr
(VIDEO OUT) jacks to the corresponding COMPONENT
VIDEO IN jacks on the TV. Use component video cable (not
supplied) and match the cable colors to the jack colors when possi-
ble.
2
Connect one pair of the DVD Player’s red and white
AUDIO OUT jacks to the left/right AUDIO IN jacks on the
TV. Use the supplied audio cables.Match the cable colors to the
jack colors.
3
Connect the supplied AC power cord to the MAINS jack on
the rear of the DVD Player.
4
Plug the power cords of the DVD Player and the TV into an
active power outlet.Press the POWER ON/OFF button on
the front of the DVD Player to turn on the DVD Player.
5
Turn on the TV power. Set the TV to the correct
Component Video In channel. Such channels usually are near
channel 00.See your TV owner’s manual for details.Or,change chan-
nels at the TV until you see the DVD screen saver on the TV.
• Set VIDEO OUTPUT to YPBPR.
Details are on page 34.
•
On the TV,the Component Video
In jacks may be labeled YUV or
Pr/Cr Pb/Cb Y and may be red,
blue,and green.
Cb is similar to Pb.“B”refers to
the blue part of the video. Cr is
similar to Pr.“R”refers to the red
part of the video.
• The Y Pb Pr jacks on the DVD
Player can send video as either
Component/Interlaced video or
Progressive Scan video.
If your TV has Progressive Scan
and you are using the DVD
Player’s Y Pb Pr jacks,you must
activate Progressive Scan.Details
are on page 35.Make sure you
are using the Progressive Scan In
or Y PB PR In jacks on the TV.Set
the TV to its Progressive Scan
Video In channel.
Helpful Hints