Manual

10 Hookups (cont'd)
o®®®®®m moooQQeeeooooooooo®®®®®e moeoQQeoe®oooooooo®o®®®m moooQQeeeooooooooo®®®®®m moooQQeeeooooooooo®®®®®m mOOOQQ.
DVD/VCR to Cable Box or Satellite Receiver and TV
Using only basic RF coaxial cables
This connection will let you use the features of both theVCR and the DVD player.
Cable
Signal
Cable Box/Satellite Receiver
RF coaxial cable
DVD/VCR
RF coaxial cable
TV's ANTENNA
IN Jack
Connections
Connect a CableTV or Satellite signal to the IN
jack on the Cable Box/Satellite Receiver.
Use an RF coaxial cable (as the one supplied) to
connect the OUT jack on the Cable Box/Satellite
Receiver to the ANT-IN (Antenna In) jack on the
DVD/VCR.
Use a second RF coaxial cable to connect the
ANT-OUT (Antenna Out) jack on the DVD/VCR to
the TV's Antenna In jack.
Plug in the power cord of yourTV.Turn on theTV
and set it to channel 3 or 4.
Plug in the power cord of the DVD/VCR.You areready to turn on the DVD/VCR. Go to page 16
before turning it on.
Remember...
There are two ways to connect your Cable Box/Satellite Receiver
to the DVD/VCR.With the connection on this page:
÷ SelectTV channels at the Cable Box/Satellite Receiver, not the
DVD/VCR.To record or viewTV channels, follow these steps:
1) PressVCR to put the DVD/VCR inVCR mode.VCR light will
appear on the front of the DVD/VCR.
2) Press SKIP I_I/CH A or SKIP I_I/CH v to set the DVD/VCR
to the Cable Box/Satellite Receiver output channel (03 or 04).
3) Set theTV to the DVD/VCR's output channel (03 or 04).The
DVD/VCR's output channel is channel 3 when the DVD/VCR is
new.To change it from 3 to 4, press and hold
(VCR) PLAY I_ on the DVD/VCR for 3-5 seconds during tape
playback. For more details, see step 4 on page 9.
4) Select the channel you want to view/record at the Cable
Box/Satellite Receiver.
÷ You may not view a channel other than the one you are recording.
÷ You can only program a timer recording for one channel at a time.
Set your Cable Box/Satellite Receiver to the channel you want to
record.When you enter the channel you want to record in a
timer recording, select channel 03 or 04 (the Cable Box/Satellite
Receiver output channel). (This is step 8 on page 28.) Leave the
Cable Box/Satellite Receiver on for a timer recording.
• If your Cable Box or Satellite
Receiver hasAudio and Video
Out jacks, use audio and video
cables to connect them to the
VCRAUDIO IN andVIDEO IN
jacks on the rear of the
DVD/VCR.You will not need
the RF coaxial cable connection
between the Cable Box/Satellite
Receiver and the DVD/VCR as
described at step 2.