Manual

14 Hookups (cont'd)
o®®®®®m moooQQeeeoo®®ooooo®®®®®m moooQQeeeooooooooo®®®®®m moooQQeee®®ooo®ooo®®®®®m moooQQeee®oooooooo®®®®®m mOOOQQ.
DVD/VCR to aTV and to a Stereo that is Dolby Digital-compatible
Using Digital Audio connections
Antenna/Cable TV Signal
Back of TV
(example onJy)
Connect the antenna or Cable TV signal to the ANT-IN (Antenna In) jack
of your DVD/VCR.
2
Connect a coaxial digital audio cable (not supplied) to the DVD/VCR's
COAXIAL DIGITAL AUDIO OUT jack and to the COAXIAL DIGITAL
AUDIO IN jack on the Stereo.
This digital audio connection only provides sound for the DVD playerof the DVD/VCR.
So,in order to use theVCR features or hear TV channelsat the DVD/VCR, you still
needto either connect the RF coaxial cable between the ANT-OUT jack of the
DVD/VCR and theTV's Antenna In jack,or connect the supplied red/white audio cables.
To connect the supplied RF coaxial cable,see step 2 on page 9.To connect the red/white
audio cables,see step 2 on page 12.
Connect the supplied yellow video cable to the yellow DVD/VCRVIDEO
OUT jack on the DVD/VCR and to theVIDEO IN jack on the'IV. To use
component video cable or S-Video cable instead for the DVD player, see
page 12.You will still need the yellow video cable or RF coaxial cable forVCR
features.
Plug in the power cords of the Stereo, TV and DVD/VCR.Turn on the
Stereo and select its Auxiliary IN channel.Turn on theTV and set it to
the correctVideo In channel. Go to your TV's lowest channel (01 or 02) and
change channels downward until you see DVD orVCR material on the-IV screen.
To help you find the rightVideo In channel on the-I-V, turn on the DVD/VCR. Press
DVD to put the DVD/VCR in DVD mode.With no disc in the player, a large DVD
Video logo will appear on theTV screen when you get theTV on the correctVideo
In channel.
Make sure PROGRESSIVE is OFF and P.SCAN does not appear on the DVD/VCR's
display panel. Disable Progressive Scan either in the DISPLAY menu or by
pressing and holding PLAY I_ (DVD) on the front of the DVD/VCR for more
than 5 seconds. Details are on pages 8 and 54.
You are ready to turn on the DVD/VCR. Go to page | 6 before turning on
the DVD/VCR.
Remember...
Some DVDs are recorded in Dolby Digital 5.1 channel Surround Sound. Select Dolby Digital
5.1 channel Surround Sound in the DVD disc menu. If Dolby Digital Surround Sound is not
recorded on the disc,you will not have surround sound available.
If you connect the DVD/VCR to a Dolby Digital Stereo, set DOLBY DIGITAL to
BITSTREAM in the DVD player's setup menu. Details are on page 55. If the DVD/VCR is not
connected to a Dolby Digital-compatible Stereo, set DOLBY DIGITAL to PCM.
Incorrect settings may cause noise distortion and damage the speakers.