Manual

16 First-time DVD/VCR Setup
Before turning on your DVD/VCR, make sure batteries are in the
remote control and the DVD/VCR and TV are connected correctly.
You cannot program channels if you are using a Cable Box or a
Satellite Receiver.
These menus may not appear if you have already turned
on the DVD/VCR.
Turn on the TV. Set it to channel 3 or 4 or its
AUDIO/VIDEO IN channel, depending on how you
connected the DVD/VCR to aTV.
2
PressVCR, then press STANDBY-ON © .VCR light will
appear on the front of the DVD/VCR.The display shown
below will appear.
These menus may not appear if you have already turned on
the DVD/VCR.You may have turned on the DVD/VCR
before to find the Audio/Video In channel of the TV, for
example. If so, follow the steps on page 21 to set up
channels and page 23 to select a language for theVCR
menus.
LANGUAGE SELECT
I_ENGLISH [ON]
FRANCAIS
ESPANOL
PUSH I_
Press • or • to select ENGLISH, FRANCAIS
(French) or ESPAI_IOL (Spanish) as the language for
VCR on-screen displays and menus. Then, press I_. The
display shown below will appear.
Turn on the TV.
PHILIPS
2
3-4
AUTO SET UP
PUSH I_
Press I_ to begin channel programming. AUTO
SETUP will flash on the TV screen during the channel
search.The DVD/VCR will memorize all available channels.
When channel programming is complete, the lowest
available channel will appear on the TV.
These channels will be available when you want to watch
TV while inVCR mode.To put the DVD/VCR inVCR
mode, pressVCR soVCR light appears. Use SKIP I_I/CH •
or SKIP I_I/CH • to select memorized channels.To select
non-memorized channels,use the Number buttons.
• To skip this feature and play a
tape immediately, insert a tape
with its record tab removed.
• If you like to skip step 4, press
DISC/VCR MENU as soon as the
search begins.The DVD/VCR will
stop the channel search, and the
VCR menus and displays will be
in English.
• If you try to program channels
when there is no antenna or
Cable TV signal connected to the
ANT-IN jack of the DVD/VCR,
programming will stop.AUTO
SET UP will stop flashing.
Connect an antenna or CableTV
signal to the DVD/VCR's
ANT-IN jack and press I_ again.
• Repeat this process if the power
fails.