Manual

54 Display (cont'd)
Instructions continued from the previous page.
÷ If you selected STILL MODE, press • or • to select a
setting, then press OK. This determines the qualityof an
imagein still mode.AUTO isthe default setting.
If you select FIELD,still images will be stabilized but
coarse due to the small amount of data.
If you select FRAME, the images will be highly defined due
to the simultaneous output of two fields.
STILL MODE
Press SYSTEM/MENU to remove the menu.
SEAPC_ MODE DISPLAY
000
_EPEAT REPEAT AUDIO
0®0®"
SUBTITLE ZOOM ANGLE SKIP/OH
000®"
_ETURN TITLE OLEAR/RESET SLOW
0000
-6
Progressive Scan
You may adjust the Progressive Scan compatibility.
Follow the steps 1-4 in the Display setup on page 53.
2
3
÷ Press • or • to select PROGRESSIVE, then press
OK repeatedly to turn PROGRESSIVE ON or OFE The
default setting is OFE Choose ON if your TV has
Progressive Scan and if the TV is connected to the
players COMPONENTVIDEO OUT jacks. Choose OFF
otherwise.
Press SYSTEM/MENU to remove the menu.
÷ If PROGRESSIVE is ON, this message appears:
Before p_oceed_ng
1. Make sure your TV _as p_0gress_vescan.
2, Connec_ with _×_mp0nerl_ v_deo cable.
NOTE: I_there s no _cture or picture _s
d_st0_od after selec_ ng 'YES',
wait about 15 s_oeds for auto rec0very,
Activate Progressive?
YES
SELECT: • / • SET:OK
Press • or • to make a selection, then press OK.
If you select NO, the menu disappears and
PROGRESSIVE is OFE If you selectYES, this appears:
Confirm again to use progressive scan.
If Picture s good, Select 'YES'.
YES
SELECT: • / • SET:OK
Confirm your setting, then press OK.The menu will
disappear and PROGRESSIVEwill be ON.
If you do not press any buttons for 15 seconds,
ProgressiveScanwill switch to OFE
• You can set PROGRESSIVE to
OFF either in the DISPLAY
menu or by pressing and
holding PLAY I_ on the front
of the player for more than 5
seconds.
• You can adjust PROGRESSIVE
in the QUICK SETUP menu
that appears when you first
press SETUP.With QUICK
selected, press OK. Press • to
select PROGRESSIVE. Press
OK to choose OFF or ON.
Press SETUP to remove the
menu.