User Manual

1. Introduction

The upgrade version of this software is Version 36

__________________________________________________________________

2. Software Upgrade Disc Preparation

Tools Required

You will need the following items :

· a personal computer

· a CD-R/RW drive and writing application software

· a blank CD-R

__________________________________________________________________

How to download the software to your computer

1) Right mouse button click on the file and click ‘Save Target As… ’ to save

the zip file into your PC.

2) Unzip the .zip file and extract files into your PC.

Do not change the filename - DVP762.bin.

__________________________________________________________________

PAGE 1
. Introduction The upgrade version of this software is Version 36 __________________________________________________________________ 2.
PAGE 2
3. Steps to upgrade DVP762 1. Burn the file (DVP762.bin) to blank CD R or CDRW, using the following settings : ·File System CD-ROM ISO Level 2 ·Mode 1/2/XA ·Character set ISO 9660 ·Finalised, single session ·Write speed slow (e.g. 2x, 4x) Finalize the disc. (The application may do this automatically.) NOTE : Packet writing application for drag & drop copying cannot be used for creating an upgrade disc. Use only a dedicated CD writing application allowing ‘disc at once’ recording. No UDF setting as well.
PAGE 3
6. Front display will then show “ERASE” and OSD will show the following: UPGRADE FILE DETECTED UPGRADING 7. After some time, the front panel display will show “WRITE.” 8. After about 2 minutes from the time the CD had been loaded in, the set would have finished upgrading and the set would reset. At this juncture, upgrading has been s uccessfully completed. 9. Open tray and press DISPLAY key on the Remote controller and check the OSD to see if the correct version has been installed.