User Manual

3. Steps to upgrade DVP762
1. Burn the file (DVP762.bin) to blank CD R or CDRW, using the following
settings :
· File System CD-ROM ISO Level 2
· Mode 1/2/XA
· Character set ISO 9660
· Finalised, single session
· Write speed slow (e.g. 2x, 4x)
Finalize the disc. (The application may do this automatically.)
NOTE : Packet writing application for drag & drop copying cannot be used
for creating an
upgrade disc. Use only a dedicated CD writing application allowing ‘disc at
once’ recording.
No UDF setting as well.
2. After burning is complete, place the CD onto the tray.
3. Close the tray.
4. Front panel display will show “LOAD” and OSD will show the following:
5. After about 20 seconds, the tray will open. At this point you MUST
remove the CD from the tray.
UPGRADE FILE DETECTED
FILE COPYING