User Guide

32 33Settings Settings
Table of contents
Table of contents
8.1.9 Enable/disable the recording indicator
This function allows you to switch o the status LED.
1
In stop mode (start-up screen), press a/MENU for at least two
seconds.
2
Press a to select the device settings menu ×.
3
Press h / b to select the function Record lamp.
4
Press the record key, g, to confirm.
5
Press h / b, to select whether you want to turn the status LED
on or o.
6
Press the record key, g, to confirm.
7
Press the ~ key to exit the menu.
Tip
• Press the ~ key to cancel the operation without saving and
return to stop mode.
8.2 Display settings
8.2.1 Select language
Note
• Your language might not be available. Select an alternative one.
1
In stop mode (start-up screen), press a/MENU for at least two
seconds.
2
Press a to select the device settings menu Ô.
3
Press h / b to select the function Language.
4
Press the record key, g, to confirm.
5
Press h / b to select the required display language.
6
Press the record key, g, to confirm.
7
Press the ~ key to exit the menu.
Tip
• Press the ~ key to cancel the operation without saving and
return to stop mode.
8.2.2 Adjusting the display contrast
1
In stop mode (start-up screen), press a/MENU for at least two
seconds.
2
Press a to select the device settings menu Ô.
3
Press h / b to select the function Contrast.
4
Press the record key, g, to confirm.
5
Press h / b to select the required display contrast.
6
Press the record key, g, to confirm.
7
Press the ~ key to exit the menu.
Tip
• Press the ~ key to cancel the operation without saving and
return to stop mode.
8.2.3 Adjusting the backlight
1
In stop mode (start-up screen), press a/MENU for at least two
seconds.
2
Press a to select the device settings menu Ô.
3
Press h / b to select the function Backlit.
4
Press the record key, g, to confirm.
5
Press h / b to select from the following settings: Off, 8s, 20s,
On.
6
Press the record key, g, to confirm.
7
Press the ~ key to exit the menu.
Tip
• Press the ~ key to cancel the operation without saving and
return to stop mode.
8.2.4 Setting demonstration mode
Using Demonstration mode you can display images on the screen.
Note
• The images, with the following properties, must be stored in the
root directory of the device: File format: 24 bit .bmp; resolution:
128 × 160 pixels; File name: 01.bmp, 02.bmp, … .
1
In stop mode (start-up screen), press a/MENU for at least two
seconds.
2
Press a to select the device settings menu Ô.
3
Press h / b to select the function Demo Mode.