Operation Manual

7Getting started
3 Getting strted
Caution
• Before you connect and install your recorder, rst
read the safety instructions (see Safety instructions).
Charging the battery
Charge the built-in battery before you use the device
for the rst time or if you haven’t used it for an extended
time period. If the battery is completely discharged and
your device turns o, allow the battery to charge for a
while before you turn on the device.
Note
• The length of the USB cable might impact the
charging speed. Longer cables usually extend the
charging time.
• While the device is connected to a computer, it can’t
be operated manually.
Before you charge the battery via computer, make sure
that your computer is turned on.
X A charging battery icon appears on the screen
and an orange indicator light illuminates,
indicating that the device is recharging.
X When the device is fully recharged, the orange
indicator light turns o.
Turn the device on and o
To turn the device on or o:
• Slide and hold the Power switch on the left side of the
device downwards for two seconds until you see the
Philips emblem on the screen.
Note
• When the battery indicator is displayed, charge
the device promptly.
Key lock
You can lock your device when it’s active to prevent any
unwanted device operations or access.
To lock the device:
• Slide the Power switch on the left side of the device
upwards towards the lock symbol.
X The lock symbol appears on the screen for a
moment.
X All buttons are locked now.
To unlock the device:
• Slide the Power switch downwards.
Connect to a computer
You can use your recorder as a USB mass storage to
conveniently store, back up and move les. Link the
device to a computer with a USB cable. Your recorder will
automatically be recognized as a mass storage device.
You don’t need to install any software.
For more information on how to connect your device to a
computer, see the illustration in Charging the battery.
Caution
• Don’t disconnect the USB cable from the device while
you are transferring les. This might cause data loss.
Note
• While the device is connected to a computer, it can’t
be operated manually.