User manual
Table Of Contents
- Contents
- Machine overview (Fig. A)
- Control panel (Fig. B)
- Introduction
- Before first use
- Brewing drinks
- Adjusting machine settings
- Removing and inserting the brew group
- Cleaning and maintenance
- AquaClean water filter
- Setting the water hardness
- Descaling procedure (30 min.)
- Ordering accessories
- Warning icons
- Troubleshooting
- Technical specifications
- Contenido
- Descripción general de la máquina (Fig. A)
- Panel de control (Fig. B)
- Introducción
- Antes del primer uso
- Preparación de bebidas
- Cambio de los ajustes de la máquina
- Retirada e inserción del grupo de preparación del café
- Limpieza y mantenimiento
- Filtro de agua AquaClean
- Establecer la dureza del agua
- Procedimiento de eliminación de los depósitos de cal (30 minutos)
- Pedido de accesorios
- Iconos de advertencia
- Solución de problemas
- Especificaciones técnicas
- Table des matières
- Vue d’ensemble de la machine (fig. A)
- Panneau de commande (fig. B)
- Introduction
- Avant la première utilisation
- Infusion de boissons
- Réglage des paramètres de la machine
- Retrait et insertion du groupe de percolation
- Nettoyage et entretien
- Filtre à eau AquaClean
- Réglage de la dureté de l’eau
- Procédure de détartrage (30 min.)
- Commande d'accessoires
- Icônes d’avertissement
- Résolution des problèmes
- Caractéristiques techniques
11
English
English
1 Check if the brew group is in the correct position. The arrow on the yellow cylinder on the side of the
brew group has to be aligned with the black arrow and N (Fig. 18).
-
If they are not aligned, push down the lever until it is in contact with the base of the brew group (Fig.
19).
2 Slide the brew group back into the machine along the guiding rails on the sides (Fig. 20) until it locks into
position with a click (Fig. 21). Do not press the PUSH button.
3 Close the service door and place back the water tank.
Cleaning and maintenance
Regular cleaning and maintenance keeps your machine in top condition and ensures good-tasting coffee
for a long time with a steady coffee flow.
Consult the table below for a detailed description on when and how to clean all detachable parts of the
machine. You can find more detailed information and video instructions on www.philips.com/coffee-care.
See figure D for an overview of which parts can be cleaned in the dishwasher.
Detachable
parts
When to clean How to clean
Brew group Weekly Remove the brew group from the machine (see
'Removing and inserting the brew group'). Rinse it
under the tap (see 'Cleaning the brew group under
the tap').
Monthly Clean the brew group with the Philips coffee oil
remover tablet (see 'Cleaning the brew group with
the coffee oil remover tablets').
Classic milk frother After every use First dispense hot water with the milk frother
attached to the machine for thorough cleaning.
Then remove the milk frother from the machine and
disassemble it. Clean all parts under the tap or in the
dishwasher.
Pre-ground coffee
compartment
Check the pre-ground coffee
compartment weekly to see if
it is clogged.
Unplug the machine and remove the brew group.
Open the lid of the pre-ground coffee compartment
and insert the spoon handle into it. Move the
handle up and down until the clogged ground
coffee falls down (Fig. 22). Go to
www.philips.com/coffee-care for detailed video
instructions.
Coffee grounds
container
Empty the coffee grounds
container when prompted by
the machine. Clean it weekly.
Remove the coffee grounds container while the
machine is switched on and rinse it under the tap.
Drip tray Empty the drip tray daily or as
soon as the red 'drip tray full'
indicator pops up (Fig. 23).
Remove the drip tray (Fig. 24) and rinse it under the
tap or clean it in the dishwasher. The front panel of
the grounds container (fig. A15) is not
dishwasher-safe.
Lubrication of the
brew group
Every 2 months Consult the lubrication table and lubricate the brew
group with the Philips grease (see 'Lubricating the
brew group').
Water tank Weekly Rinse the water tank under the tap.