User Guide
Table Of Contents
- Contents
- Machine overview (Fig. A)
- Control panel (Fig. B)
- Introduction
- Before first use
- Brewing drinks
- Adjusting machine settings
- Removing and inserting the brew group
- Cleaning and maintenance
- AquaClean water filter
- Setting the water hardness
- Descaling procedure (30 min.)
- Ordering accessories
- Troubleshooting
- Technical specifications
- İçerik
- Makineye genel bakış (Şek. A)
- Kontrol paneli (Şek. B)
- Giriş
- İlk kullanımdan önce
- İçecek hazırlama
- Makineyi ayarlama
- Demleme ünitesini takma ve çıkarma
- Temizlik ve bakım
- AquaClean su filtresi
- Su sertliğini ayarlama
- Kireç çözme işlemi (30 dk.)
- Aksesuarların sipariş edilmesi
- Sorun giderme
- Teknik özellikler
- สารบัญ
- ภาพรวมของเครื่อง (รูป A)
- แผงควบคุม (รูป B)
- ข้อมูลเบื้องต้น
- ก่อนใช้งานครั้งแรก
- การชงเครื่องดื่ม
- การปรับการตั้งค่าเครื่อง
- การถอดและใส่หัวชง
- การทำความสะอาดและบำรุงรักษา
- ตัวกรองน้ำ AquaClean
- การตั้งค่าความกระด้างของน้ำ
- ขั้นตอนการขจัดคราบตะกรัน (30 นาที)
- การสั่งซื้ออุปกรณ์เสริม
- การแก้ปัญหา
- ข้อมูลทางเทคนิค
- المحتويات
- نظرة عامة على الماكينة (الشكل أ)
- لوحة التحكم (الشكل ب)
- مقدمة
- قبل أول استخدام
- تحضير المشروبات
- ضبط إعدادات الماكينة
- إزالة مجموعة التحضير وتركيبها
- التنظيف والصيانة
- فلتر مياه AquaClean
- ضبط عسر الماء
- إجراء إزالة الترسبات (30 دقيقة)
- طلب الملحقات
- استكشاف الأخطاء وإصلاحها
- المواصفات الفنية
- فهرست مطالب
- نمای کلی دستگاه (شکل A)
- کنترل پنل (شکل B)
- معرفی
- قبل از اولین استفاده
- دم کردن نوشیدنیها
- انجام تنظیمات دستگاه
- بیرون آوردن و جا انداختن مجموعه دمکردن
- تمیز کردن و سرویس کردن دستگاه
- فیلتر آب AquaClean
- تنظیم سختی آب
- فرآیند رسوبزدایی (30 دقیقه)
- سفارش لوازم جانبی
- عیب یابی
- مشخصات فنی
15
English
English
4 Reassemble the two milk frother parts and reattach the milk frother to the machine.
AquaClean water filter
Your machine is AquaClean enabled. You can place the AquaClean water filter in the water tank to preserve
the taste of your coffee. It also diminishes the need for descaling by reducing limescale build-up in your
machine. You can purchase an AquaClean water filter from your local retailer, from authorized service
centers or online at www.philips.com/parts-and-accessories.
AquaClean icon and light
Your machine is equipped with an AquaClean water filter light (Fig. 40) to indicate the status of the filter.
Use the table below to see what actions are required when the light is on or when it is flashing.
When you use the machine for the first time, the AquaClean light starts flashing
orange. This indicates that you can start using the AquaClean water filter. If you do not
activate an AquaClean water filter, the light will switch off automatically after a while.
Once you have installed the filter and activated it with the AquaClean icon, the
AquaClean light turns blue to confirm that the AquaClean water filter is active.
When the filter is exhausted, the AquaClean light starts flashing orange again to
remind you to replace the filter with a new one.
When the orange AquaClean light is off, you can still activate an AquaClean filter, you
will need to descale the machine first.
Activating the AquaClean water filter (5 min.)
The machine does not automatically detect that a filter has been placed in the water tank. Therefore you
need to activate each new AquaClean water filter that you install with the AquaClean icon.
When the orange AquaClean light is off, you can still activate an AquaClean water filter, but you will need
to descale the machine first.
Your machine has to be completely limescale-free before you start to use the AquaClean water filter.
Before activating the AquaClean water filter, it has to be prepared by soaking it in water as described below.
If you don't do this, air might be drawn into the machine instead of water, which makes a lot of noise and
prevents the machine from being able to brew coffee.
1 Make sure that the machine is switched on.
2 Shake the filter for about 5 seconds (Fig. 41).
3 Immerse the filter upside down in a jug with cold water and shake/press it (Fig. 42).
4 The filter is now prepared for use and can be inserted into the water tank.
5 Insert the filter vertically onto the filter connection in the water tank. Press it down to the lowest possible
point (Fig. 43).
6 Fill the water tank with fresh water and place it back into the machine.
7 If attached, remove the LatteGo.
8 Place a bowl under the hot water spout/milk frother.
9 Press the AquaClean icon for 3 seconds (Fig. 44). The start light starts to pulse.
10 Press the start/stop button to start the activation process.
11 Hot water will be dispensed from the hot water spout/milk frother (3 min.).