User Manual

Table Of Contents
18
English
3 Before brewing any drinks, perform a manual rinsing cycle. To perform a manual rinsing cycle, first
dispense half a water tank of hot water by repeatedly tapping the hot water icon (Fig. 14) and then brew
2 cups of pre-ground coffee without adding ground coffee.
If the descaling procedure was not completed, the machine will require another descaling procedure as
soon as possible.
Ordering accessories
To clean and descale the machine, only use the Philips maintenance products. These products can be
purchased from your local retailer, from the authorized service centers or online at
www.philips.com/parts-and-accessories. To find a full list of spare parts online, enter the model number
of your machine. You can find the model number on the inside of the service door.
Maintenance products and type numbers:
-
Descaling solution CA6700
-
AquaClean water filter CA6903
-
Brew group grease HD5061
-
Coffee oil remover tablets CA6704
Troubleshooting
This chapter summarizes the most common problems you could encounter with the machine. Support
videos and a complete list of frequently asked questions are available on www.philips.com/coffee-care. If
you are unable to solve the problem, contact the Consumer Care Center in your country. For contact details,
see the warranty leaflet.
Warning icons
Warning
icon
Solution
The 'water tank empty' light is on
- The water tank is almost empty. Fill the water tank with fresh water to the maximum
level indication.
- The water tank is not in place. Place back the water tank.
The 'empty coffee grounds container' light is on
- The coffee grounds container is full. Remove and empty the coffee grounds container
while the machine is switched on. Wait at least 5 seconds before you reinsert the
container.
The alarm light is on
- The coffee grounds container and/or the drip tray is not in place or not placed
correctly. Place back the coffee grounds container and/or the drip tray and make sure
they are in the correct position.
- The service door is open. Remove the water tank and make sure the service door is
closed.