Fully automatic espresso machine 1200 series 2200 series 3200 series EN USER MANUAL DA BRUGERVEJLEDNING DE BENUTZERHANDBUCH ES MANUAL DEL USUARIO FR MODE D’EMPLOI IT MANUALE UTENTE NL GEBRUIKSAANWIJZING NO BRUKERHÅNDBOK PT MANUAL DO UTILIZADOR FI KÄYTTÖOPAS SV ANVÄNDARHANDBOK EL ΕΓΧΕΙΡΊΔΙΟ ΧΡΉΣΗΣ www.philips.com/coffee-care OMNIA COVER_FRONT_A5_WE/EE/RCA.
A A1 A2 A3 A4 A6 A7 A8 A5 A13 A9 A14 A10 A15 A11 A16 A17 A18 A12 A19 A20 A21 A22 A23 B5 B6 A24 B B1 B2 B3 B4 My Coffee Choice B11 B10 B7 B8 B9
C 1200 series 2200 series 3200 series A19 A20 A21 A22 A21 A15 A23 A24 Classic Milk Frother EP1220 Classic Milk Frother EP2220 EP2221 EP2224 EP3221 LatteGo EP2230 EP2231 EP2235 EP3241 EP3243 EP3246 EP3249 D A18 A17 A16 A14 A24 A23 A9 A4 A12
English 7 Machine overview (Fig. A) ____________________________________________________________________________ 7 Control panel (Fig.
English 8 Some of the buttons/icons are for specific types only.
English 9 2. Activating the AquaClean water filter (5 min.) English For more information see chapter 'AquaClean water filter'. 3 sec. 30 sec. 5 sec. 3 min. 3. Setting the water hardness For more information see chapter 'Setting the water hardness'. OFF = 1 sec. 3 sec. 1 min. 3x ON 4. Assembling LatteGo (specific types only) CLICK 5.
10 English Brewing drinks General steps 1 Fill the water tank with tap water and fill the bean hopper with beans. 2 Press the on/off button to switch on the machine. - The machine starts heating up and performs the automatic rinsing cycle. During heating up, the lights in the drinks icons light up and go out slowly one by one. - When all lights in the drink icons light up continuously, the machine is ready for use. 3 Place a cup under the coffee dispensing spout.
11 3 Fill LatteGo with milk up to the level indicated on the milk container for the drink you are brewing (Fig. 8). Do not fill the milk container beyond the MAX indication. If you have personalized the milk quantity, you may need to fill the milk container with more or less milk than indicated for this drink on LatteGo. Always use milk coming directly from the fridge for optimal results. 4 Place a cup on the drip tray. 5 Tap the milk-based drink icon of your choice.
12 English Pre-ground coffee is not a setting that is saved as a previous selected strength setting. Each time you want to use pre-ground coffee, you need to press the aroma strength icon for 3 seconds. When you select pre-ground coffee, you cannot select a different aroma strength. Dispensing hot water 1 If attached, remove LatteGo or the milk frother. 2 Tap the hot water icon (Fig. 14). - The drink quantity lights go on and show the previous selected drink setting for hot water.
English 13 Machines without temperature icon 1 Press the on/off button to switch off the machine. 2 When the machine is switched off: press and hold the coffee quantity icon until the lights in this icon go on (Fig. 16). 3 Tap the quantity icon to select the required temperature: normal, high or max. - Respectively 1, 2 or 3 lights are on. 4 When you have finished setting the coffee temperature, press the start/stop button. 5 Press the on/off button to switch on the machine again.
14 English Removing the brew group from the machine 1 Switch off the machine. 2 Remove the water tank and open the service door (Fig. 18). 3 Press the PUSH handle (Fig. 19) and pull at the grip of the brew group to remove it from the machine (Fig. 20). Reinserting the brew group Before you slide the brew group back into the machine, make sure it is in the correct position. 1 Check if the brew group is in the correct position.
English 15 When to clean How to clean Coffee grounds container Empty the coffee grounds Remove the coffee grounds container while the container when prompted by machine is switched on. Rinse it under the tap the machine. Clean it weekly. with some washing-up liquid or clean it in the dishwasher. The front panel of the coffee grounds container is not dishwasher-safe. Drip tray Empty the drip tray daily or as soon as the red 'drip tray full' indicator pops up through the drip tray (Fig. 26).
16 English 9 Tap the coffee icon and then press the aroma strength icon for 3 seconds to select the pre-ground coffee function (Fig. 2). Do not add pre-ground coffee. Press the start/stop button to start the brewing cycle. Repeat this twice. Empty the cup. Lubricating the brew group Lubricate the brew group every 2 months, to ensure that the moving parts continue to move smoothly. 1 Apply a thin layer of grease on the piston (grey part) of the brew group (Fig. 29).
17 When you use the machine for the first time, the AquaClean light starts flashing orange. This indicates that you can start using the AquaClean water filter. If you do not activate an AquaClean water filter, the light will switch off automatically after a while. Once you have installed the filter and activated it with the AquaClean icon, the AquaClean light turns blue to confirm that the AquaClean water filter is active.
18 English When the orange AquaClean light flashes: 1 Take out the old AquaClean water filter. 2 Install a new filter and activate it as described in chapter 'Activating the AquaClean water filter (5 min.)'. Replace the AquaClean water filter at least every 3 months, even if the machine does not yet indicate that replacement is required. Setting the water hardness We advise you to adjust the water hardness to the water hardness in your region for optimal performance and a longer lifetime of the machine.
19 7 The first phase of the descaling procedure starts. The descaling procedure lasts approx. 30 minutes and consists of a descaling cycle and a rinsing cycle. During the descaling cycle the Calc / Clean light flashes to show that the descaling phase is in progress. 8 Let the machine dispense the descaling solution until the display reminds you that the water tank is empty. 9 Empty the water tank, rinse it and then refill it with fresh water up to the Calc / Clean indication.
20 English Troubleshooting This chapter summarizes the most common problems you could encounter with the machine. Support videos and a complete list of frequently asked questions are available on www.philips.com/coffeecare. If you are unable to solve the problem, contact the Consumer Care Center in your country. For contact details, see the warranty leaflet. Warning icons Warning icon Solution The 'water tank empty' light is on - The water tank is almost empty.
English Solution The lights of all warning icons are flashing. Reset the machine by unplugging it and plugging it back in. Before switching the machine back on, follow these steps: - Remove the AquaClean water filter from the water tank. - Place back the water tank. Push it into the machine as far as possible to make sure it is in the right position. - Open the lid of the pre-ground coffee compartment and check if this is clogged with coffee powder.
22 English Problem Cause Solution The coffee grounds container is too full and the 'empty coffee grounds container' light did not go on. You removed the drip tray without emptying the grounds container. When you remove the drip tray, also empty the coffee grounds container even if it contains only a few coffee pucks. In this way the coffee grounds counter will be reset to zero, re-starting to correctly count the coffee pucks. I cannot remove the brew group.
Problem Coffee does not come out or coffee comes out slowly. 23 Cause Solution Adding milk reduces the temperature of the drink. Regardless of whether you add hot or cold milk, adding milk always reduces the temperature of the coffee. Preheat the cups by rinsing them with hot water. The AquaClean water filter was not prepared properly for installation. Remove the AquaClean water filter and try to brew a coffee again.
24 English Problem Cause Solution Machines with LatteGo: the milk Disassemble LatteGo and rinse both container and/or frame of parts under the tap or clean them in the LatteGo are dirty. dishwasher (see 'Cleaning LatteGo after every use'). Machines with classic milk frother: the milk frother is dirty. Thoroughly clean the milk frother (see 'Cleaning the classic milk frother '). The type of milk used is not suitable for frothing.
English Cause Solution The machine is making a It is normal that your machine loud noise. makes noise during use. If the machine starts to make a different kind of noise, clean the brew group and lubricate it (see 'Lubricating the brew group'). The AquaClean water filter was not prepared properly and air is now drawn into the machine. Remove the AquaClean water filter from the water tank and properly prepare it for use before you place it back.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 CLICK Steam 1 2 1 2
26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 2 1 5 sec. 30 sec. 41 42 43 = 3 sec. 1 sec. 45 2 44 46 1 Aqua Clean 1 min.
fillpage Saeco
Fully automatic espresso machine 1200 series 2200 series 3200 series www.philips.com/coffee-care 4219.450.0118.1_OMNIA COVER_BACK_A5_WEU.