User Guide
Table Of Contents
- Contents
- Machine overview (Fig. A)
- Control panel (Fig. B)
- Introduction
- Before first use
- Brewing drinks
- Adjusting machine settings
- Removing and inserting the brew group
- Cleaning and maintenance
- AquaClean water filter
- Setting the water hardness
- Descaling procedure (30 min.)
- Ordering accessories
- Troubleshooting
- Technical specifications
- İçerik
- Makineye genel bakış (Şek. A)
- Kontrol paneli (Şek. B)
- Giriş
- İlk kullanımdan önce
- İçecek hazırlama
- Makineyi ayarlama
- Demleme ünitesini takma ve çıkarma
- Temizlik ve bakım
- AquaClean su filtresi
- Su sertliğini ayarlama
- Kireç çözme işlemi (30 dk.)
- Aksesuarların sipariş edilmesi
- Sorun giderme
- Teknik özellikler
- สารบัญ
- ภาพรวมของเครื่อง (รูป A)
- แผงควบคุม (รูป B)
- ข้อมูลเบื้องต้น
- ก่อนใช้งานครั้งแรก
- การชงเครื่องดื่ม
- การปรับการตั้งค่าเครื่อง
- การถอดและใส่หัวชง
- การทำความสะอาดและบำรุงรักษา
- ตัวกรองน้ำ AquaClean
- การตั้งค่าความกระด้างของน้ำ
- ขั้นตอนการขจัดคราบตะกรัน (30 นาที)
- การสั่งซื้ออุปกรณ์เสริม
- การแก้ปัญหา
- ข้อมูลทางเทคนิค
- المحتويات
- نظرة عامة على الماكينة (الشكل أ)
- لوحة التحكم (الشكل ب)
- مقدمة
- قبل أول استخدام
- تحضير المشروبات
- ضبط إعدادات الماكينة
- إزالة مجموعة التحضير وتركيبها
- التنظيف والصيانة
- فلتر مياه AquaClean
- ضبط عسر الماء
- إجراء إزالة الترسبات (30 دقيقة)
- طلب الملحقات
- استكشاف الأخطاء وإصلاحها
- المواصفات الفنية
- فهرست مطالب
- نمای کلی دستگاه (شکل A)
- کنترل پنل (شکل B)
- معرفی
- قبل از اولین استفاده
- دم کردن نوشیدنیها
- انجام تنظیمات دستگاه
- بیرون آوردن و جا انداختن مجموعه دمکردن
- تمیز کردن و سرویس کردن دستگاه
- فیلتر آب AquaClean
- تنظیم سختی آب
- فرآیند رسوبزدایی (30 دقیقه)
- سفارش لوازم جانبی
- عیب یابی
- مشخصات فنی
23
English
English
Problem Cause Solution
The water tank is not fully
inserted and air is drawn into the
machine.
Make sure the water tank is in the correct
position: remove it and insert it again
pushing it as far as possible.
The brew group is dirty/clogged. Rinse the brew group.
The machine is not placed on a
horizontal surface.
Place the machine on a horizontal surface
so that the drip tray does not overflow
and the 'drip tray full' indicator works
properly.
The water tank is not fully
inserted and air is drawn into the
machine.
Make sure the water tank is in the correct
position: remove it and insert it again
pushing it as far as possible.
I cannot activate the
AquaClean water filter
and the machine asks for
descaling.
The filter has not been installed or
replaced in time after the
AquaClean water filter light
started to flash. This means your
machine is not completely
limescale free.
Descale your machine first and then install
the AquaClean water filter.
The new water filter does
not fit.
You are trying to install another
filter than the AquaClean water
filter.
Only the AquaClean water filter fits into
the machine.
The rubber ring on the AquaClean
water filter is not in place.
Place back the rubber ring on the
AquaClean water filter.
The machine is making a
loud noise.
It is normal that your machine
makes noise during use.
If the machine starts to make a different
kind of noise, clean the brew group and
lubricate it (see 'Lubricating the brew
group').
The AquaClean water filter was
not prepared properly and air is
now drawn into the machine.
Remove the AquaClean water filter from
the water tank and properly prepare it for
use before you place it back. See chapter
'AquaClean water filter' for step-by-step
instructions.
The water tank is not fully
inserted and air is drawn into the
machine.
Make sure the water tank is in the correct
position: remove it and insert it again
pushing it as far as possible.
Technical specifications
The manufacturer reserves the right to improve the technical specifications of the product. All the preset
quantities are approximate.
Description Value
Size (w x h x d) 246 x 372 x 433 mm
Weight 7 - 7.5 kg
Power cord length 1000 mm