User Guide
Table Of Contents
- Contents
- Machine overview (Fig. A)
- Control panel (Fig. B)
- Introduction
- Before first use
- Brewing drinks
- Adjusting machine settings
- Removing and inserting the brew group
- Cleaning and maintenance
- AquaClean water filter
- Setting the water hardness
- Descaling procedure (30 min.)
- Ordering accessories
- Troubleshooting
- Technical specifications
- Contenido
- Descripción general de la máquina (Fig. A)
- Panel de control (Fig. B)
- Introducción
- Antes del primer uso
- Preparación de bebidas
- Cambio de los ajustes de la máquina
- Retirada e inserción del grupo de preparación del café
- Limpieza y mantenimiento
- Filtro de agua AquaClean
- Establecer la dureza del agua
- Procedimiento de eliminación de los depósitos de cal (30 minutos)
- Pedido de accesorios
- Solución de problemas
- Especificaciones técnicas
- Table des matières
- Vue d’ensemble de la machine (fig. A)
- Panneau de commande (fig. B)
- Introduction
- Avant la première utilisation
- Infusion de boissons
- Étapes générales
- Personnalisation des boissons
- Préparation d’un café à partir de grains
- Préparation des boissons à base de lait avec le LatteGo (récipient à lait)
- Production de mousse de lait avec le mousseur à lait classique
- Infuser du café avec du café prémoulu
- Préparation du café glacé (certains modèles uniquement)
- Distribution d’eau chaude
- Réglage des paramètres de la machine
- Retrait et insertion du groupe de percolation
- Nettoyage et entretien
- Filtre à eau AquaClean
- Réglage de la dureté de l’eau
- Procédure de détartrage (30 min.)
- Commande d'accessoires
- Résolution des problèmes
- Caractéristiques techniques
21
English
English
Troubleshooting table
This chapter summarizes the most common problems you could encounter with the machine.
Support videos and a complete list of frequently asked questions are available on
www.philips.com/coffee-care. If you are unable to solve the problem, contact the Consumer Care
Center in your country. For contact details, see the warranty leaflet.
Problem Cause Solution
The drip tray fills up
quickly.
This is normal. The machine
uses water to rinse the internal
circuit and brew group. Some
water flows through the
internal system directly into the
drip tray.
Empty the drip tray daily or as soon as
the red 'drip tray full' indicator pops up
through the drip tray cover. Tip: place
a cup under the dispensing spout to
collect rinsing water that comes out of
it.
The 'empty coffee
grounds container' light
remains on.
You emptied the coffee
grounds container while the
machine was switched off.
Always empty the coffee grounds
container while the machine is
switched on. Remove the coffee
grounds container, wait at least 5 sec.
and then insert it again.
The machine prompts
to empty the coffee
grounds container even
though the container is
not full.
The machine did not reset the
counter the last time you
emptied the coffee grounds
container.
Always wait approx. 5 seconds when
you place back the coffee grounds
container. In this way the coffee
grounds counter will be reset to zero.
Always empty the coffee grounds
container while the machine is
switched on. If you empty the coffee
grounds container when the machine
is switched off, the coffee grounds
counter won't reset.
The coffee grounds
container is too full and
the 'empty coffee
grounds container' light
did not go on.
You removed the drip tray
without emptying the grounds
container.
When you remove the drip tray, also
empty the coffee grounds container
even if it contains only a few coffee
pucks. In this way the coffee grounds
counter will be reset to zero, re-
starting to correctly count the coffee
pucks.
I cannot remove the
brew group.
The brew group is not in the
correct position.
Reset the machine in the following
way: close the service door and place
back the water tank. Switch the
machine off and back on again. Try
again to remove the brew group. See
chapter 'Removing and inserting the
brew group' for step by step
instructions.