Super automatic espresso machine 3100 series EP3519, EP3510 4219.460.3770.1 PHILIPS3100 CMF_FRONT-BACK_A5_WE.
1 2 3 4 6 STEAM ESPRESSO AROMA STRENGTH 11 7 HOT WATER COFFEE 12 8 MENU 13 5 9 10 16 15 14 17 34 18 33 32 31 19 30 20 21 29 22 23 24 28 27 25 26
4 English Contents Machine overview_________________________________________________________________ Introduction ______________________________________________________________________ First installation___________________________________________________________________ AquaClean filter __________________________________________________________________ Activating the AquaClean filter_______________________________________________________ Replacing the AquaClean filter______________________________________
English 5 Machine overview 1 User interface 18 Drip tray 2 ESPRESSO button 19 Cord 3 COFFEE button 20 Grind setting knob 4 AROMA STRENGTH button 21 Cover of bean hopper 5 Standby button 22 Bean hopper 6 STEAM button 23 Brew group 7 HOT WATER button 24 Inside of service door with contact information 8 MENU button 25 Coffee exit duct 9 Classic milk frother 26 Coffee residues drawer 10 Adjustable coffee dispensing spout 27 Coffee grounds container 11 Lid of water tank
6 English - This is the QR code. Scan this code to access instruction videos on how to brew the best coffees, how to clean the machine and for a list of frequently asked questions. (www.philips.com/coffee-care) - The separate booklet with important safety information. First installation For first installation, follow the instructions on the separate quick start guide. Note: This machine has been tested with coffee. Although it has been carefully cleaned, there may be some coffee residues left.
English AQUA CLEAN FILTER 0/8 7 2 Press the MENU button, select MENU and press the OK button to confirm. Scroll to AQUACLEAN FILTER. Press the OK button to confirm. - The display shows the number of AquaClean filters that have been installed previously from 0 to 8 filters. 3 Select ON on the display, press the OK button to confirm. ON OFF 0/8 4 The display automatically updates the number of filters used.
8 English AQUA CLEAN FILTER 2/8 - The display automatically updates the number of filters used. 4 Dispense 2 cups of hot water (0.5 l) to complete the activation. Discard this water. Replacing the AquaClean filter after 8 filters were used 1 DESCALE BEFORE ACTIVATING FILTER When the filter icon starts flashing on the display, press the MENU button, scroll to AQUACLEAN FILTER and press the OK button to confirm.
English 9 Control panel and display This espresso machine has a self-explaining display for easy use. Read the sections below for a quick explanation of the buttons. One-touch beverage buttons Use the one-touch beverage buttons to quickly prepare one of the preset beverages: ESPRESSO, COFFEE, STEAM and HOT WATER. Navigation buttons Some of the one-touch beverage buttons have a double function; use these buttons to navigate through the menu.
10 English Brewing coffee Brewing coffee with beans Caution: Only use espresso beans. Never put ground coffee, unroasted coffee beans or caramelized coffee beans in the bean hopper, as this may cause damage to the machine. To brew coffee, follow the instructions on the separate quick start guide. To brew two cups of espresso, press the ESPRESSO button twice. The machine automatically carries out two grinding cycles in sequence. Note: Using the cover of the bean hopper helps to keep the beans fresh.
English 11 1 Fill 1/3 of a jug with cold milk. 2 Insert the classic milk frother into the milk. 3 Press the STEAM button. - The machine starts dispensing steam. 4 Froth the milk by gently swirling the jug and moving it up and down. 5 Press the OK button to stop frothing. Hot water Warning: Danger of scalding! Dispensing may be preceded by small jets of hot water. Use the appropriate protective handle only. 1 Place a jug under the classic milk frother. 2 Press the HOT WATER button.
English 12 - The machine enters the programming phase and starts to brew the selected beverage. 2 Press the OK button when the cup contains the desired amount of espresso. - The tick on the display shows that the button is programmed: every time it is pressed, the machine brews the set espresso volume.
English 13 Cleaning and maintenance Note: Consult the table below for when and how to clean all detachable parts of the machine. For more detailed information on how to clean the brew group and how to descale the machine, read the corresponding chapters below and visit the dedicated website www.philips.com/coffeecare. Cleaning table Part description When to clean How to clean Brew group Weekly Remove the brew group and clean it under the tap (see 'Cleaning the brew group under the tap').
English 14 Cleaning the brew group Note: Scan the QR code or visit www.philips.com/coffee-care for support videos on how to remove and clean the brew group. Caution: Do not clean the brew group in the dishwasher and do not use washing-up liquid or a cleaning agent to clean it. This may cause the brew group to malfunction and may have a negative effect on the coffee taste. Cleaning the brew group under the tap 1 Switch off the machine and unplug it.
English 15 3 Put a coffee oil remover tablet in the pre-ground coffee compartment. 4 Press the CLASSIC COFFEE button. The machine dispenses water from the coffee dispensing spout. 5 When the progress bar has reached the middle, set the main switch on the back of the machine to OFF. 6 Let the coffee oil remover solution act for approximately 15 minutes. 7 Set the main switch to ON. Press the standby button. 8 Wait until the machine performs an automatic rinsing cycle.
16 English - The hook is not positioned correctly if it is still in bottommost position. 3 Slide the brew group back into the machine along the guiding rails on the sides until it locks into position with a click. Caution: Do not press the PUSH button. 4 Close the service door. Lubrication For optimal performance of the machine, you have to lubricate the brew group. See table below for the lubrication frequency. For support videos visit our website: www.philips.com/coffee-care.
English 17 Cleaning the classic milk frother After the last usage of the day 1 Remove the classic milk frother from the steam wand and rinse it with fresh water. 2 Clean the steam wand with a wet cloth. 3 Reassemble all the classic milk frother parts. Descaling procedure When the display shows START CALC CLEAN, you need to descale the machine. If you do not descale the machine when this message appears on the display, the machine will eventually stop working properly.
18 English 2 1 XAM CLAC C NAEL CALC CLEAN 5 Pour the descaling solution into the water tank. Fill the water tank with fresh water up to the CALC CLEAN level indication. Place the water tank back into the machine. Press the OK button to confirm. - The first phase of the descaling procedure starts. The machine starts dispensing the descaling solution at intervals. - The display shows the descaling icon, the phase indication and the duration. This first phase takes 20 minutes.
English 19 Warning icons and error codes Meaning of the warning icons ADD WATER ADD COFFEE 10 xx Fill the water tank with fresh water to the MAX level indication. The brew group is blocked by coffee powder. Clean the brew group. The bean hopper is empty. Put new coffee beans in the bean hopper. Insert the drip tray and close the service door. The brew group is not in the machine or it is not inserted correctly. Insert the brew group.
20 English Error code Problem Cause Possible solution The brew group is not Switch off the machine. Remove the positioned correctly. brew group and reinsert it. Make sure the two reference signs on the side match before you slide the brew group back into the machine (see 'Reinserting the brew group'). Then switch the machine on again. 05 There is a water circuit problem. There is air in the water circuit. Switch off the machine. Make sure you insert the water tank into the machine properly.
English 21 Problem Cause Solution The drip tray fills up quickly. This is normal. The machine uses water to rinse the internal circuit and brew group. Some water flows through the internal system directly into the drip tray. Empty the drip tray when the 'drip tray full' indicator pops up through the drip tray cover. Place a cup under the dispensing spout to collect rinsing water. The 'coffee grounds container full' icon remains displayed.
22 English Problem Cause Solution The coffee exit duct is clogged. Clean the coffee exit duct with the handle of the measuring spoon or a spoon handle. Then switch the appliance off and on again. The cups you use are cold. Preheat the cups by rinsing them with hot water. The temperature is set too low. Check the menu settings. Set the temperature to 'high' in the menu. You added milk. Whether the milk you add is warm or cold, it always decreases the temperature of the coffee to some extent.
English 23 Problem Cause Solution There is water under the machine. The drip tray is too full and has overflowed. Empty the drip tray when the 'drip tray full' indicator pops up through the drip tray. Always empty the drip tray before you start descaling the machine. The machine is not placed on a horizontal surface. Place the machine on a horizontal surface so that the 'drip tray full' indicator works properly. You have already replaced the AquaClean filter 8 times.
START DESCALING? 23 MIN empty page before backcover
www.philips.com/coffee-care 4219.460.3770.1 PHILIPS3100 CMF_FRONT-BACK_A5_WE.