User Manual
Table Of Contents
- Contents
- Machine overview (Fig. A)
- Control panel
- Introduction
- Before first use
- Brewing drinks
- Personalizing drinks
- Adjusting machine settings
- Removing and inserting the brew group
- Cleaning and maintenance
- AquaClean water filter
- Descaling procedure (30 min.)
- Ordering accessories
- Troubleshooting
- Technical specifications
- Contenido
- Descripción general de la máquina (Fig. A)
- Panel de control
- Introducción
- Antes del primer uso
- Preparación de bebidas
- Bebidas personalizadas
- Cambio de los ajustes de la máquina
- Retirada e inserción del grupo de preparación del café
- Limpieza y mantenimiento
- Filtro de agua AquaClean
- Procedimiento de eliminación de los depósitos de cal (30 minutos)
- Pedido de accesorios
- Solución de problemas
- Especificaciones técnicas
- Table des matières
- Vue d’ensemble de la machine (fig. A)
- Panneau de commande
- Introduction
- Avant la première utilisation
- Infusion de boissons
- Étapes générales
- Préparation d’un café à partir de grains
- Préparation des boissons à base de lait avec le LatteGo (récipient à lait)
- Production de mousse ou chauffage du lait avec le mousseur à lait classique
- Jet supplémentaire ExtraShot (certains modèles uniquement)
- Infuser du café avec du café prémoulu
- Distribution d’eau chaude
- Personnalisation des boissons
- Réglage des paramètres de la machine
- Retrait et insertion du groupe de percolation
- Nettoyage et entretien
- Filtre à eau AquaClean
- Procédure de détartrage (30 min.)
- Commande d'accessoires
- Résolution des problèmes
- Caractéristiques techniques
Warning icons
Warning
icon
Solution
The 'water tank empty' icon pops up on the display.
-
The water tank is almost empty. Fill the water tank with fresh water to the
maximum level indication.
-
The water tank is not in place. Place back the water tank.
The 'add beans' icons pops up on the display.
-
Fill the bean hopper with coffee beans.
The 'empty coffee ground container' icon pops up on the display.
-
The coffee grounds container is full. Remove and empty the coffee
grounds container while the machine is switched on. Wait 5 seconds
before you place it back.
The 'insert brew group' icon pops up on the display.
-
The brew group is not in place or not placed correctly. Remove the brew
group and make sure it is locked into place. See chapter 'Removing and
inserting the brew group' for step-by-step instructions.
Error codes
Below you find a list of the error codes showing problems that you can solve yourself. Video
instructions are available on https://www.usa.philips.com/c-m-ho/coffee/your-philips-
espresso-machine. If another error code appears, please contact the Philips Consumer Care
Center in your country. For contact details, see the warranty leaflet.
Error
code
Problem Possible solution
01 The coffee funnel is
clogged.
Switch off the machine and unplug it. Remove the brew
group. Then open the lid of the pre-ground coffee
compartment and insert the spoon handle. Move the
handle up and down until the clogged ground coffee falls
down. Visit https://www.usa.philips.com/c-m-
ho/coffee/your-philips-espresso-machine for detailed
video instructions.
03 The brew group is
dirty or not well-
greased.
Switch off the machine. Rinse the brew group with fresh
water, let it air-dry and then lubricate it. Consult chapter
'Cleaning the brew group' or visit
https://www.usa.philips.com/c-m-ho/coffee/your-
philips-espresso-machine for detailed video instructions.
Then switch the machine on again.
22
English