User Manual
Table Of Contents
- Contents
- Machine overview (Fig. A)
- Control panel
- Introduction
- Before first use
- Brewing drinks
- Personalizing drinks
- Adjusting machine settings
- Removing and inserting the brew group
- Cleaning and maintenance
- AquaClean water filter
- Descaling procedure (30 min.)
- Ordering accessories
- Troubleshooting
- Technical specifications
- Contenido
- Descripción general de la máquina (Fig. A)
- Panel de control
- Introducción
- Antes del primer uso
- Preparación de bebidas
- Bebidas personalizadas
- Cambio de los ajustes de la máquina
- Retirada e inserción del grupo de preparación del café
- Limpieza y mantenimiento
- Filtro de agua AquaClean
- Procedimiento de eliminación de los depósitos de cal (30 minutos)
- Pedido de accesorios
- Solución de problemas
- Especificaciones técnicas
- Table des matières
- Vue d’ensemble de la machine (fig. A)
- Panneau de commande
- Introduction
- Avant la première utilisation
- Infusion de boissons
- Étapes générales
- Préparation d’un café à partir de grains
- Préparation des boissons à base de lait avec le LatteGo (récipient à lait)
- Production de mousse ou chauffage du lait avec le mousseur à lait classique
- Jet supplémentaire ExtraShot (certains modèles uniquement)
- Infuser du café avec du café prémoulu
- Distribution d’eau chaude
- Personnalisation des boissons
- Réglage des paramètres de la machine
- Retrait et insertion du groupe de percolation
- Nettoyage et entretien
- Filtre à eau AquaClean
- Procédure de détartrage (30 min.)
- Commande d'accessoires
- Résolution des problèmes
- Caractéristiques techniques
Problem Cause Solution
I cannot insert the
brew group.
The brew group is not in the
correct position.
Reset the machine in the following
way: close the service door and
place back the water tank. Leave the
brew group out. Switch the machine
off and unplug it. Wait for 30 sec.
and then plug the machine back in
and switch it on and wait for the
lights in the drinks icons to come on.
Then put the brew group in the
correct position and reinsert it into
the machine. See chapter 'Removing
and inserting the brew group' for
step by step instructions.
The coffee is watery. The brew group is dirty or
needs to be lubricated.
Remove the brew group (see
'Removing the brew group from the
machine'), rinse it under the tap and
leave it to dry. Then lubricate the
moving parts (see 'Lubricating the
brew group').
The machine is performing its
self-adjustment procedure.
This procedure is started
automatically when you use
the machine for the first time,
when you change to another
type of coffee beans or after
a long period of non-use.
Brew 5 cups of coffee initially to
allow the machine to complete its
self-adjustment procedure.
The grinder is set to a too
coarse setting.
Set the grinder to a finer (lower)
setting. Brew 2 to 3 drinks to be able
to before taste the full difference.
The coffee is not hot
enough.
The temperature is set too
low.
Set the temperature to the
maximum setting. To adjust the
temperature, press the 'Settings'
icon.
A cold cup reduces the
temperature of the drink.
Preheat the cups by rinsing them
with hot water.
Adding milk reduces the
temperature of the drink.
Regardless of whether you add hot
or cold milk, adding milk always
reduces the temperature of the
coffee. Preheat the cups by rinsing
them with hot water.
25
English
English