User Manual
Table Of Contents
- Contents
- Machine overview (Fig. A)
- Control panel
- Introduction
- Before first use
- Brewing drinks
- Personalizing drinks
- Adjusting machine settings
- Removing and inserting the brew group
- Cleaning and maintenance
- AquaClean water filter
- Descaling procedure (30 min.)
- Ordering accessories
- Troubleshooting
- Technical specifications
- Contenido
- Descripción general de la máquina (Fig. A)
- Panel de control
- Introducción
- Antes del primer uso
- Preparación de bebidas
- Bebidas personalizadas
- Cambio de los ajustes de la máquina
- Retirada e inserción del grupo de preparación del café
- Limpieza y mantenimiento
- Filtro de agua AquaClean
- Procedimiento de eliminación de los depósitos de cal (30 minutos)
- Pedido de accesorios
- Solución de problemas
- Especificaciones técnicas
- Table des matières
- Vue d’ensemble de la machine (fig. A)
- Panneau de commande
- Introduction
- Avant la première utilisation
- Infusion de boissons
- Étapes générales
- Préparation d’un café à partir de grains
- Préparation des boissons à base de lait avec le LatteGo (récipient à lait)
- Production de mousse ou chauffage du lait avec le mousseur à lait classique
- Jet supplémentaire ExtraShot (certains modèles uniquement)
- Infuser du café avec du café prémoulu
- Distribution d’eau chaude
- Personnalisation des boissons
- Réglage des paramètres de la machine
- Retrait et insertion du groupe de percolation
- Nettoyage et entretien
- Filtre à eau AquaClean
- Procédure de détartrage (30 min.)
- Commande d'accessoires
- Résolution des problèmes
- Caractéristiques techniques
Brewing coffee with beans
1 To brew a coffee, tap the drink icon of your choice (Fig. 3) or tap the 'More Drinks' icon (Fig.
4) (specific types only).
-
You can now adjust the drink to your personal taste (Fig. 5). Use the up and down arrows
(Fig. 6) to adjust the coffee strength. Tap the OK icon if you want to adjust more settings
(Fig. 7).
2 Press the start/stop
button at any time to start brewing the selected drink.
3 To stop dispensing coffee before the machine is finished, press the start/stop
button
again.
To brew 2 coffees at the same time, tap the drink icon twice or select the 2x icon scrolling
the dedicated bar.
Do not use caramelized or flavored coffee beans.
Brewing milk-based drinks with LatteGo (milk container)
LatteGo consists of a milk container, a frame and a storage lid. To avoid leakage, make sure
the frame and the milk container are properly assembled before you fill the milk container.
1 To assemble LatteGo, first insert the top of the milk container under the hook at the top of
the frame (Fig. 8). Then press home the bottom part of the milk container. You hear a click
when it locks into place (Fig. 9).
Note: Make sure that the milk container and the frame are clean before you connect them.
2 Slightly tilt LatteGo and put it on the hot water spout (Fig. 10). Then press it home until it
locks into place (Fig. 11).
3 Fill LatteGo with milk (Fig. 12). Do not fill the milk container beyond the maximum
indication.
If you have personalized the milk quantity, you may need to fill the milk container with
more or less milk than indicated for this drink on LatteGo.
Always use milk coming directly from the fridge for optimal results.
4 Place a cup on the drip tray.
5 Tap the milk-based drink icon of your choice or tap the 'More Drinks' icon (specific types
only) to select a different drink (see 'Personalizing drinks')
-
You can now adjust the drink to your own preference.
6 Press the start/stop
button.
-
When you brew cappuccino, flat white or latte macchiato, the machine first dispenses
milk and then coffee. When you brew caffè latte or café au lait, the machine first
dispenses coffee and then milk.
-
To stop dispensing milk before the machine has dispensed the preset amount, press the
start/stop
button.
7 To stop dispensing the complete drink (milk and coffee) before the machine is finished,
press and hold the start/stop
button.
11
English
English