Essence 5000 Series Rechargeable sonic toothbrush
1
English General description (Fig. 1) A B C D E F G H I , Travel cap Extra soft bristles Brush head Personalized ID ring Removable nut Power on/off button & charge indicator light Charger base with cord wrap Power cord Brush head holder Refer to bottom of charger for voltage specifications. IMPORTANT SAFEGUARDS READ ALL INSTRUCTIONS BEFORE USE DANGERS To reduce the risk of electrocution: 1 Do not place or store product where it can fall or be pulled into a tub or sink.
English 10 This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. 11 Children should be supervised to ensure that they do not play with the appliance. 12 Sonicare is a personal care device and is not intended for use on multiple patients in a dental office or institution.
English 2 Screw the brush head nut clockwise until it’s firmly tightened. If the brush head rattles when in use, tighten the nut further. 3 Remove the travel cap from your brush head when you are ready to brush. 4 Use the cord wrap in the bottom of the charger to store excess cord. Charging your Sonicare\ Sonicare comes with the batteries completely discharged and should be charged for at least 24 hours during the first few days of use.
English , A fully charged Sonicare will provide approximately 2 weeks of typical use (2 minutes of brushing twice a day), making it easy to travel without the charger. Remember that voltage converters and plug adapters DO NOT guarantee voltage compatibility. Always check for voltage compatibility. Brushing technique Follow these simple steps to maximize your brushing experience. 45º 1 Before turning the Sonicare on, place the bristles of the brush head on your gumline at a 45-degree angle.
English Periodontal pockets , Your dental professional may have indicated that you have periodontal pockets, deep pockets where plaque bacteria collect. If this is the case, after brushing for a full 2 minutes, spend extra time gently brushing these areas to improve your gum health. Features Easy-start \ brushing power ramp-up , All Sonicare models come with the Easy-start feature activated (on), which helps you get used to brushing with Sonicare.
English 1 2 4 3 Quadpacer\ 30-second interval timer (available on select models). , Quadpacer makes sure that you brush all sections of your mouth evenly and thoroughly. At 30, 60 and 90 seconds, you will hear a short beep and a pause in brushing action. This is your signal to move to the next section of your mouth. Battery charge indicator (available on select models).
English , Press down gently on the white area. Avoid using sharp objects to push on the seal as this may cause damage. , Pull the nut up over the top of the brush head To replace the nut, slip the nut over the brush head shaft and pull until it clicks back on. 3 Clean and dry the handle periodically. 4 Clean the charger base periodically. UNPLUG the charger before cleaning. After cleaning the charger base, completely dry the charger before plugging it into an electrical outlet.
10 English Environment HANDLE CONTAINS NICKEL CADMIUM BATTERIES. BATTERIES MUST BE RECYCLED OR DISPOSED OF PROPERLY. The batteries inside your Sonicare cannot be replaced, but are easily removed for recycling. At the end of product life and prior to disposal, please remove the batteries from the handle by following the instructions below. , To help protect our environment, we encourage you to recycle at approved recycling locations. Do not dispose of the batteries in normal household waste.
English 11 11 4 Now, insert the screwdriver into the middle slot located on the top front part of the handle as shown and push the blade in as far as it will go. 5 Now use the screwdriver as a lever to pry the 2 handle sections apart. 6 Pull the 2 handle sections completely apart. 7 Insert the screwdriver underneath the electronic circuit board in multiple places. 8 Twist and pry the electronic circuit board loose until it is completely separated from the handle.
12 English 9 Pry the 2 AA-sized cylindrical nickel-cadmium batteries loose by inserting the screwdriver on the sides of the two batteries in the locations shown in the figure. 10 Use a twisting and prying motion to break the glue bond around the batteries. The 2 batteries are joined together with glue and will be lifted out together. Guarantee and service Philips guarantees its products for two years after the date of purchase.
English 13 13 LIMITATION, LOSS OF SAVINGS OR REVENUE; LOSS OF PROFIT; LOSS OF USE; THE CLAIMS OF THIRD PARTIES INCLUDING, WITHOUT LIMITATION, DENTISTS AND DENTAL HYGIENISTS; AND COST OF ANY SUBSTITUTE EQUIPMENT OR SERVICES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSQUENTIAL DAMAGES.
www.philips.com/support ©2008 Koninklijke Philips Electronics NV (KPENV). All rights reserved. PHILIPS and the Philips shield are registered trademarks of KPENV. Quadpacer, Smartimer, Easy-start, Sonicare and the Sonicare logo are trademarks of Philips Oral Healthcare, Inc. and/or KPENV. Printed in the U.S.A. Printed on 100% recycled paper. Protected by U.S. and international patents. Other patents pending. 4235.020.1537.