Important Information Manual

-
The wetting strip with the icon with one drop and the light blue mopping pad with narrow stripes
are suitable for mopping laminate and water-resistant parquet and wooden floors.
Using liquid floor cleaner in the water tank
If you want to add a liquid floor cleaner to the water in the water tank, make sure that you use a low-
foaming or non-foaming liquid floor cleaner that can be diluted in water. As the water tank has a
capacity of 200ml, you only have to add a few drops of liquid floor cleaner to the water.
Cleaning the water tank
To clean the water tank, mix one part vinegar with three parts water. Pour this mixture into the water
tank and close the cap. Shake the water tank and put the water tank on a water-resistant surface.
Leave the water-vinegar mixture in the water tank overnight. Then empty the water tank, rinse it
thoroughly with fresh water, and use it normally again.
Ordering accessories
To buy accessories or spare parts, visit www.shop.philips.com/service or go to your Philips dealer.
You can also contact the Philips Consumer Care Centre in your country (see the international warranty
leaflet for contact details).
Warranty and support
If you need information or support, please visit www.philips.com/support or read the international
warranty leaflet.
Recycling
-
Do not throw away the product with the normal household waste at the end of its life, but hand it
in at an official collection point for recycling. By doing this, you help to preserve the environment.
Troubleshooting
This chapter summarizes the most common problems you could encounter with the appliance. If you
are unable to solve the problem with the information below, visit www.philips.com/support for a list of
frequently asked questions or contact the Consumer Care Center in your country.
Problem
Possible cause Solution
The appliance does not
work when I push the
button.
The battery light flashes fast
because the batteries are
low.
To charge the batteries, insert the small
plug into the socket on the appliance
and insert the adapter into a wall socket.
You cannot use the
appliance because the
appliance is still charging.
You have to remove the small plug from
the socket on the appliance before you
can switch on the appliance.
You have to press two
buttons.
First press the on/off button to switch
on the appliance. Then press the MAX
button to get maximum suction power.
8
English