User manual

11 Slide the holder with dustbag into the appliance in such a way that the holder is kept in place
by the two ridges in the container (Fig. 17).
12 Put the motor unit back into the container and close the clamps (‘click’). (Fig. 18)
13 Put the micro lter into place (specic types only) (Fig. 19).
Note: See chapter ‘Replacement’ for replacing the paper dustbag or chapter ‘Cleaning and maintenance’
for emptying the reusable dustbag (some countries only).

Always remove the paper or reusable dustbag (some countries only) and the micro lter (specic
types only) before wet use.

To vacuum liquids, you need the oat unit and the diffuser.
1 Make sure the appliance is unplugged.
2 Undo the clamps (Fig. 10).
3 Lift the motor unit from the container by the handle (Fig. 11).
4 Remove the reusable dustbag (some countries only) or the paper dustbag (see chapter
‘Replacement’) (Fig. 20).
5 Insert the oat unit into the container by its handle (Fig. 21).
Note: The oat unit only ts into the appliance in one way.
6 Turn the motor unit upside down (Fig. 12).
7 Insert the diffuser into the motor unit (Fig. 22).
8 Put the motor unit back into the container and close the clamps (‘click’) (Fig. 18).
9 Remove the micro lter (specic types only) (Fig. 23).
Note: If the micro lter is exposed to excessive air humidity, it loses its electrostatic properties.
Now the appliance is ready for vacuuming liquids.

To shampoo oors, you need the oat unit, the diffuser, the shampoo reservoir (lled with shampoo
and water), the double-injection nozzle and the shampoo trigger.
1 Follow steps 1 to 9 in ‘Preparing for vacuuming liquids’.
2 Fill the shampoo reservoir with cold water (Fig. 24).
3 Add one measuring cup of cleaning liquid to the full reservoir (Fig. 25).
4 Attach the shampoo reservoir to the appliance (Fig. 26).
5 Insert the short shampoo hose into the connector on the vacuum cleaner (1) and turn it
anticlockwise (2) (Fig. 27).
6 Connect the long shampoo hose to the shampoo trigger (Fig. 28).
7 Fasten the shampoo trigger to the handgrip of the suction hose (Fig. 29).
8 Firmly insert the end of the long shampoo hose into the connector on the vacuum cleaner
(‘click’) (Fig. 30).
- To release the shampoo hose, push the ring towards the appliance (Fig. 31).
 9