Manual

◗ To adjust the nozzle to the type of floor and the area to be cleaned, put your foot on the
indicated spot and then turn the tube until the nozzle is in the required position.(fig.8)
1 With the nozzle positioned breadthwise and the brush strip folded out, you can clean large
hard floor areas.Turn the nozzle until the brush strip pops out of the nozzle housing and the
nozzle is positioned breadthwise.(fig.9)
2 With the nozzle positioned lengthwise and the brush strip folded out, you can vacuum clean
small hard floor areas.Turn the tube 90 degrees anti-clockwise until it is positioned
lengthwise with the brush strip still folded out of the nozzle housing.(fig.10)
3 With the nozzle positioned breadthwise and the brush strip folded in, you can vacuum clean
large soft floor areas.Turn the tube 90 degrees anti-clockwise again to position the nozzle
breadthwise and to make the brush strip disappear into the nozzle housing.(fig.11)
4 With the nozzle positioned lengthwise and the brush strip folded in, you can vacuum clean
small soft floor areas.Turn the tube 90 degrees anti-clockwise again until it is positioned
lengthwise with the brush strip still folded in.(fig.12)
Crevice tool and small nozzle
1 Connect the crevice tool (1) or small nozzle (2) directly to the handgrip or to the
tube.(fig.13)
Accessory holder
1 The accessory holder can simply be snapped onto the handgrip.(fig.14)
◗ The crevice tool and the small nozzle can be stored in the accessory holder by pushing them
in the holder.(fig.15)
Please note the way in which the small nozzle must be placed in the accessory holder.
Vacuum cleaning
Adjusting suction power
◗ You can adjust the suction power while vacuum cleaning
1 Adjust the suction power by means of the electronic suction power control.(fig.16)
2 Set the knob to MAX for maximum suction power.(fig.17)
Use maximum suction power for vacuum cleaning very dirty carpets and hard floors.
3 Set the knob to MIN for minimal suction power.
Use minimum power for vacuum cleaning curtains, table carpets, etc.
Parking the tube
◗ By inserting the ridge on the nozzle in the parking slot, you can park the tube in a convenient
position.(fig.18)
Storing the vacuum cleaner
1 You can put the appliance in upright position and attach the nozzle to the appliance by
inserting the ridge on the nozzle in the slot.(fig.19)
Replacing the dustbag
1 Replace the dustbag as soon as the dustbag-full indicator changes colour (even when the
nozzle is not placed on the floor).(fig.20)
ENGLISH 7