User Manual

11
English
3139 115 20612
➜ "TEST TONE" followed by "ADAPT
BALANCE, CENTER AND REAR LEVEL" will
be displayed.
➜ The test signal will last for about 90 seconds.
Adjust the sound level
+
-
+
-
Front speakers
● Press BALANCE L on the remote control for
left speaker and press BALANCE R on the
remote control for right speaker.
➜ "BAL L +XX" or "BAL R +XX" will be
displayed.
Centre speaker
● Press CENTER + or - on the remote
control.
➜ "CENT +XX" or "CENT-XX" will be
displayed.
Surround speakers
● Press REAR + or - on the remote control.
➜ "REAR +XX" or "REAR -XX" will be
displayed.
To switch off the TEST TONE
● Press TEST TONE and then DPL on the
remote control.
Notes:
– It is advisable to set the speakers’ level at
normal listening level.
–"XX" denotes the sound level.
Switching the Dolby Pro Logic
● Press PRO LOGIC (DPL)
repeatedly to select and cycle
through the various sound
modes.
➜ The Dolby Pro Logic display
panel will light up with the
selection.
Dolby Surround ➜ Dolby Center Phantom
➜ Dolby 3 Stereo ➜ Stereo ➜ Dolby
Surround …
Dolby Surround
This setting is for a full
Dolby Surround Pro
Logic mode.
➜ “DOLBY SURROUND”
will be displayed.
Dolby Center Phantom
This setting is for use
without the centre
speaker. It redistributes
the centre speaker
sound to the left and right speakers, providing
conventional stereo across the front.
➜ “ DOLBY CENTER PHANTOM” will be
displayed.
Dolby 3 Stereo
Use this setting when full
surround is not required,
but a wide stereo sound
is desired. It requires
only the left, right and
centre speakers.
➜ “DOLBY 3 STEREO” will be displayed.
Normal Stereo
This setting is for normal
stereo sound without
Dolby Pro Logic. It
requires only the left and
right speakers.
➜ “STEREO” will be displayed.
Dolby Pro Logic
L
S
SURROUND
SPEAKERS
CENTER
LEFT RIGHT
S
C
R
L
S
SURROUND
SPEAKERS
CENTER
LEFT RIGHT
S
C
R
L
S
SURROUND
SPEAKERS
CENTER
LEFT RIGHT
S
C
R
L
S
SURROUND
SPEAKERS
CENTER
LEFT RIGHT
S
C
R
PRO LOGIC
pg 001-031/P750/22-Eng 3/7/01, 4:13 PM11