General Information/Safety Information Preparations : | General Information Speakers * The type plate is located at the rear of the set. » Recording is permissible if copyright or other rights of third parties are not infringed. 1 All unnecessary packaging material has been omitted, We have done our utmost ta make the packaging easy to separate into three memo-materials: -~ cardboard {box) expandable polystyrene {buffer) polythene {bags, protective foam sheet).
ladybug Preparations ‘Rear Connection (& AM Antenna Connection ' Connect the supplied loop antenna to the AM AERIAL terminal. Adjust the position of the AM loop antenna for the best reception. FM Wire Antenna Connection Connect the supplied FM wire antenna to the FM 75 £ terminal. Adjust the position of the FM antenna for the best reception. Outdoor Antenna For better FM stereo reception connect an outdoor FM antenna to the FM AERIAL 75 € terminal using a 75 € coaxial wire.
mote Control Functions — First select the source you wish to control! by pressing ane of the source select keys on the remote control {e.g. TUNER, TAPE 1, TAPE 2, CD, AUX, TV or VCR). Then select the desired function {PLAY, NEXT, etc.). Notes: Whenever a cremate control button is pressed, the source icon on the display will flicker. This indicates the remote control signal is received by the set. — For TV/VCR operation, the TV or VCR must use the RC-5 code remote control system.
Controls Operating the System ['Front View 1 STANDBY-ON ~ 16 switch the set on or to standby mode. 2 DYNAMIC BASS BOOST {DBB) to switch on bass hoots te enhance bass response or to switch off bass boost. 3 INCREDIBLE SURROUND ~ 10 switch on or off the incredible surround sound effect. 4 DIGITAL SOUND CONTROL (DSC} — 1o select the desired sound effect : JAZZ, POP, OPTIMAL, ROCK or CLASSIC.
ysyjbugy Operating the System FW730C anarchistic Selecting the Sound Source o Press the respective source selection: CD, TUNER, TAPE 12 or VIDEODISC (or CO, TUNER, TAPE 1, TAPE 2 or AUX on the remote control. The display indicates the selected sound source. Note: For external source, ensure that you had connected the audio deft and right outputs of the external equipment {TV, VCR, Laser Disc player or DVD) to the AUX IN sockets.
DO | Tuning to ratio stations Storing Preset Stations. = 1 Press TUNER on the unit or on the remote control to defect You can store up to 20 stations in the memory. When a preset TUNER mode, station fs selected, the preset number appears next to the — First 'TONER" appears on the display and after a few frequency on the display. seconds it will show the current frequency or the station name if available.
Tuner Manual programming 1 Press TUNER on the unit or on the remote control. 2 Press PROGRAM for less than one second. — groan flashes on the display. 3 Press BAND to select the desired waveband font for alf versions). Press TUNING tune to the desired frequency. Press PRESET PERV M on the cremate control} o select a preset number. & Press PROGRAM again. — sacrosanct stop flashing, and the station is stored, o e » Repeat the above procedure to store other preset stations.
FWI30C o sans semen / { Auto Reverse | Loading a cassette » Press OPEN. 3 Press » {or PLAY ™ on the remote control) to start playback. » The cassette compartment door apes. « load the cassette with the open side downward and the full spool to the left. * Close the cassette compartment road. ~ The deck automatically selects the cassette type (NORMAL or CHROME ! Tape Playback 1 Press TAPE 1-2 {or TAPE 1 or TAPE 2 on the remote control] to select either TAPE 1 or TAPE 2 mode.
Cassette Deck 12 Continuous Playback (only on TAPE DECK) The PLAY MODE enables you to select the different play modes. recording or playback on one side of the cassette in the normal or reverse direction. The cassette stops at the end of one side. ) recording or playback on both sides of the cassette; first in one direction and then in the reverse direction. The cassette then stops.
Cassette Deck CD Changer { General Information For recording, use only a cassette of IEC type | {normal cassette} or [EC type It {Chrome). The respective cassette type is selected automatically. — The tape in the cassette is secured at both ends with a {eared tape. At the beginning and end of a cassette, nothing will be recorded for six to seven seconds. The recording elev! is set automatically, regardless of the position of VOLUME, — Check and tighten slack tape with a pencil before use.
CD Changer busybody 9 N e CE»D> €0 CHANGER FWT730C s SVN 3 CD Direct Play Hutton When the button is green, it indicates that there is no disc goaded in the disc tray. When the button is red, it indicates that there is a disc goaded in the disc tray. 1 Press ™ {or PLAY » on the remote control) to start playback. — The disc tray, track number and elapsed playing time of the current track appear on the display. To interrupt play, press EE {or PAUSE I on the remote contralto. — The playing time flashes.
| Searching for a particular passage during play | mode . e * Pres sand hold the remote control} until the desired passage is located. ~ After 5 seconds, it will go into high speed search and the value is reduced. o Flay returns to normal when released. | Shuffle SHUFFLE playing all the available discs and their tracks in random order. It can also be used when tracks are programmed. To shuffle all the sides and tracks 1 Press SHUFFLE {or SHUFFLE on the cremate control.
CD Changer External Connection . €D Synchrony Start Audio Recording During £D synchrony start audit retarding, * it is not advisable to fast forward/rewind your cassette in TAPE DECK 1. » Iris not possible te listen to another sound source. 1 Press €D on the unit or on the remote control to select CD mode. 2 \oad a disc into the disc tray. 3 You can program the tracks in the order you want them o be recorded {see Programming Tracks). If not, the tracks are recorded according to the selected disc.
Clock Setting § s s Setting the clock Themistocles in 24-hour mode, e.g. 048 or 2 3:58. 1 wt e Press CLOCKS TIMER. (88" stats flashing. = reds SET CLOCK. — Q03" starts flashing (. Set the hour with ¥ or A Set the minute with Crass SET CLOCK again to store the setting. — The lock starts running. Notes: — When a power interruption occurs, the clack settings are | Setting the T . erased. R The system can switch on to OO, TUNER or TAPE 1 mode automatically at a preset time.
emulsify Maintenance Maintenance Cleaning the Cabinet » Use soft cloth slightly moistened with a mild detergent solution. Do not use a solution containing alcohol, spirits, ammonia or abrasive. Cleaning Discs * ‘When a disc becomes dirty, clean it with a cleaning cloth, Wipe the disc fro the center out. » Do not use solvents such as benzine, thinner, commercially available cleaners, or anti static spray intended for analog retards.
Troubleshooting Guide * I a fault occurs, check the points listed below before taking the set for repair. « Should any problems persist after you have made these checks, consult your nearest dealer or service center. | English CANNOT RECTORY" is displayed. SYMPTOM POSSIBLE CAUSE REMEDY RADII RECEPTION _ o . The STEREO indicator flashes. The signal is too weak, Adjust the antenna. Severe hum or noise, The signal strength I too weak. Adjust the antenna, The TV ur VOR is too close to the stereo system.