User Manual

11
3139 116 17601
English
Dolby Surround
This setting is for a full Dolby Surround Pro Logic mode.
TV
CENTER
SPEAKER
SURROUND
RIGHT
SURROUND
LEFT
FRONT
LEFT
FRONT
RIGHT
MINI HIFI
SYSTEM
• Press DPL PRO LOGIC to select Dolby Surround
mode.
™ The message “DOLBY SURROUND” will be
displayed.
DPL
Front Left and Right Speakers
For best listening effect, it is recommended to have the
Left and Right speakers to form an angle of
approximately 45 degrees to the listener. The speakers
are magnetic shielded. Should the magnetic field from
the speakers affect the picture of the television, you
should increase the separation distance.
Center Speaker
For best directional effect, try to have the center speaker
at the same height as the left and right speakers and as
close as possible to the screen. Place it directly above or
beneath the television set. If you use speaker from other
make ensure that it is magnetically shielded.
Rear (surround) Speakers
The surround speaker should be placed at normal
listening ear level. It can also be mounted on the wall at
the back of the room. Most important , sometimes you
need to experiment creatively when placing the surround
speakers in order to obtain the most ideal sound
projection.
Test Tone
This feature enables you to adjust the Front Left, Front
Right, Center and Surround sound level of the respective
speakers in Dolby Pro Logic mode.
You must sit at the ideal sitting position and use
the remote control to perform this operation.
1 Press CD, TUNER, TAPE or AUX to switch on the
system.
2 Press TEST TONE.
™ A test signal is generated and it will move through
the Left, Center, Right and Surround speakers
respectively.
™ “TEST TONE” will be displayed and followed by
“ADAPT BALANCE, CENTER AND REAR
LEVEL” message.
™ The test signal will last for about 90 seconds.
3 Press the BALANCE -to adjust the desired sound
level of front left speaker.
™ The display will show the sound level and
“BAL L+XX”.
4 Press the BALANCE +to adjust the desired sound
level of front right speaker.
™ The display will show the sound level and
“BAL R+XX”.
5 Press the CENTER + or - to adjust the sound level
of center speaker.
™ The display will show either
“CENT +XX or -XX”.
6 Press the REAR + or - to adjust the desired sound
level of surround speaker.
™ The display will show either
“REAR +XX or -XX”.
7 Adjust the sound level of all the speakers until they
are of the same apparent loudness. When you are
satisfied with the setting, press TEST TONE again to
switch off the test signal.
Note:
– It is advisable to set the speakers’ level at normal
listening level. “ XX ” denotes the sound level.
When you have completed the Dolby Pro Logic setup, you
are ready to experience and enjoy a Home Cinema sound
ambience.
• Press DPL on the remote control
repeatedly to select and cycle through
the various sound mode.
Dolby Surround ™ Center Phantom ™ Dolby 3
Stereo ™ Stereo ™ Dolby Surround …
DOLBY PRO LOGIC
pg 001-27/FW775-765P/22-Eng 9/1/99, 9:37 AM11