operation manual
11
English
OPERATING THE SYSTEM
To start the demonstration mode
• Press and hold STOP•CLEAR Ç
(on
the system only)
for
5 seconds
when
the system is in standby mode.
™ The demonstration will begin.
Easy Set
EASY SET allows you to store all available
radio stations and RDS stations
automatically.
1 Press and hold STANDBY•ON
(on the
system only)
for
5 seconds
; when the
system is in standby or demonstration
mode.
™ “EASY SET” will be displayed,
and followed by “TUNER” and then
“AUTO”.
™ EASY SET will start searching for all
radio stations with RDS and then
followed by radio stations on FM,
MW and LW band respectively.
™ All available RDS and radio stations
with sufficient signal strength will be
stored. Up to 40 presets may be
stored.
2 The system will proceed to set the RDS
time automatically with the stored RDS
preset station.
• If no RDS station is available in the first
preset station, the program will exit
automatically.
™ After a radio station is found,
“EASY SET” will be displayed
and followed by “TIME”
• When searching RDS time;
™ “SEARCH RDS TIME” will be
displayed.
™ When RDS time is read, “RDS
TIME” will be displayed. The
current time will be displayed for 2
seconds and stored automatically.
Notes:
– EASY SET will start with the RDS
station, if there are still presets
available, it will continue to store the
FM, MW and LW bands respectively.
– When EASY SET is used, all previously
stored radio stations will be replaced.
– The last preset radio station or the first
available RDS station will appear on the
display when EASY SET is completed.
– If RDS station does not transmit RDS
time within 90 seconds, the program
will exit automatically and the display
will show “
NO RDS TIME
”.
Switching the system ON
• Press CD, TUNER, TAPE or AUX.
You can also switch on the system by
pressing any one of the CD DIRECT PLAY
buttons.
INTERACTIVE SOUND STUDIO
TAPECD
PROG
CLOCK/
TIMER
NEWS!
RDS
DOLBY B
NR
DUB
(HSD)
REC
STANDBY
ON
A.REV
TUNER AUX
PRESET
▲
▲
STOP•CLEARSEARCH • TUNING PLAY • SIDE
CD1 • 2 • 3
CDR
BAND
TAPE 1 • 2
J
O
G
NEWS/TA
RDS/
CD TEXT
DOLBY B
NR
M
A
X
S
O
U
N
D
MIC
MIC
LEVEL
V
O
L
U
M
E
SURF
DSC
PERSONAL
DBB
HOLD
STROBE VEC
PAN
SOUND CONTROL
DISPLAY
MAX
VEC
DBB
M
O
R
E
E
N
T
E
R
MINI HIFI SYSTEM
Important:
Before you operate the system,
complete the preparation procedures.
Demonstration mode
The system has a demonstration mode that
shows the various features offered by the
system.
When the system is switched
on for the first time, the demonstration
mode will start automatically.
Notes:
– During the demonstration, if you press
any source (or standby-on) button, the
system will switch to the respective
mode (or standby).
– When the system is switched to standby
mode, the demonstration will resume 5
seconds later.
To stop the demonstration mode
• Press and hold STOP•CLEAR Ç
(on
the system only)
for
5 seconds
when
the system is in demonstration mode.
™ The demonstration will stop.
™ "DEMO OFF" is displayed.
™ The system will switch to standby
mode.
™ About 5 seconds later, the system
will go into an energy saving mode
( < 2 watts ). The low power
STANDBY ON LED will be lit.
Note:
– Even though the AC power cord is
removed from and reconnected to the
wall socket, the demonstration will
remain off until it is switched on again.