operation manual

20
English
Selecting External Equipment
If you have connected the audio out
terminals of the external equipment (TV,
VCR, Laser Disc player, DVD player, or CD
Recorder) to the AUX/CD-R IN terminals,
you can hear the enhanced sound from the
system.
• Press AUX to select the CDR mode.
™ "CDR" will be displayed.
• Press AUX again to select external
mode.
™ "AUX" will be displayed.
Notes:
– There are two AUX modes:
i. the normal AUX mode.
ii. the CDR mode; where the LINE OUT
of this mini system is muted. You will
not be able to record or listen to the
sound from the LINE OUT.
– You are advised not to listen to and
record from the same source
simultaneously.
– All the sound control features (e.g. DSC,
VEC, DBB, etc.) are available for
selection.
TAPE AUX KARAOKE
Microphone Mixing
1 Set the MIC LEVEL control to the
minimum level to prevent acoustic
feedback (e.g. a loud howling sound)
before you connect the microphone.
2 Connect a microphone to the MIC
socket.
3 Press CD, TUNER, TAPE or AUX.
4 Play the selected source.
5 Adjust the volume level with VOLUME
control.
6 Adjust the MIC LEVEL control to the
mixing level that you want.
7 Start singing or talking through the
microphone.
Note:
– Keep the mic away from the speakers to
prevent howling.
MIC
MIC
LEVEL
– C-120 tape is extremely thin and is
easily deformed or damaged. It is not
recommended for use in this system.
– Store the tapes at room temperature
and do not put them too close to a
magnetic field (for example, a
transformer, TV, or speaker).
Dolby B Noise Reduction
System
1 Press DOLBY B NR to switch on Dolby
B NR.
™ The d B NR appears in the display.
2 Press DOLBY B NR again to switch off
Dolby B NR.
™ The d B NR disappears from the
display.
Note:
– A tape recorded with the Dolby B NR
system should also be played in the
Dolby B NR mode. If you forget to
operate the DOLBY NR button, the
treble may be reproduced too strongly.
TAPECD
PROG A.REV
TUNER AUX
PRESET
▲
▲
STOP•CLEARSEARCH • TUNING PLAY • SIDE
CD1 • 2 • 3
CDR
BAND
TAPE 1 • 2
E
R