User manual

14 EN
4 Get started
Caution
• Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact <brand>, you will be asked for
the model and serial number of this apparatus.
The model number and serial number are on
the back of the apparatus. Write the numbers
here:
Model No. __________________________
Serial No. ___________________________
Prepare the remote control
1 Press and push the battery compartment
to slide it open (see "1" in the illustration).
2 Insert one AAA battery with correct
polarity (+/-) as indicated.
3 Push and slide back the battery
compartment (see "3" in the illustration).
Note
• The battery shall not be exposed to excessive heat
suchassunshine,reorthelike.
• If you are not going to use the remote control for a
long time, remove the battery.
• Batteries contain chemical substances, so they should
be disposed of properly.
Turn on
• Press .
» The unit switches to the last selected
source.
Switch to standby mode
• Press again to switch the unit to standby
mode.
» The backlight on the display panel
turns off.
To switch to ECO Power standby mode:
• Press and hold for more than two
seconds.
» The display panel is dimmed.
» The ECO power indicator on the left
of the display panel lights up red.
Note
• The unit switches to Eco Power standby mode after 10
minutes in standby mode.
To switch between normal standby mode and
ECO Power standby mode:
» Press and hold for more than two
seconds.
Install radio stations
automatically
When you connect power and no radio
stations are stored, the unit automatically begins
to store radio stations.
1 Connect the unit to power supply.
» [AUTO FM INSTALL - PRESS PLAY--
STOP CANCEL] (auto FM install
- press PLAY to start - press STOP to
cancel) is displayed.